Examples of using Float valve in English and their translations into Slovak
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
Screw in the float valve assembly.
The water level in the tank is controlled by the float valve.
A worn float valve may also be the reason for the leakage.
The picture of the new and old float valve needles.
Wear on the blower float valve, so that it does not ensure tightness.
If the level is not sufficient,adjust the angle of the arm of the float valve.
The storage tank is equipped with a float valve, which controls the level of incoming water.
You are now here:Introductory page» Catalogue» Sanitary production» Float valves.
You will be reassembling with a new float valve assembly from the carburetor tune up kit.
Its function is toprevent ingress of water from the tank into the room in case of a float valve malfunction.
I then removed carb and checked float valve and all gaskets and seals which looked ok.
Titanium vessels include various types of towers with stirred reactors, various types(fillers,sieves, float valves and blister).
An important element of the system is a float valve connected to a float regulating the water level in the tank.
Loosen cap nut disposed between the flexible liner and a float valve, as well as bolts.
It consists of a float valve that is installed in the water compartment of the EasyGreen, and can be connected to any faucet.
On the tank, in the upper part,above the extreme water level that is set by the float valve, mark the holes for the inch fitting.
For example, when a float valve is passed through which the tank is accumulated with liquid, and in the absence of an emergency drain, it will overfill, and excess water will flood the neighbors.
The amount of fuel in thecarburetor bowl is controlled by the float and float valve assembly that keeps the bowl full of fuel.
The float floats on the fuel and adjust the float valve so that it comes in just enough fuel to make the fuel to keep a constant level.
Joseph Bramah invented a hinged valve or'crank valve' that sealed the bottom of the bowl, and a float valve system for the flush tank.
I am assuming at least some of my no start problem isbeing caused by flooding due to the main float valve not closing properly, either due to a bad/dirty seat, and/or improper float settings.
Although not the original inventor, Crapperpopularized the siphon system for emptying the tank, replacing the earlier floating valve system which tended to leak.
He was not the original inventor, butpopularized the siphon system for emptying the tank, replacing the earlier floating valve system which was prone to leaks.
Remove the float, float and valve assembly.
Floating Ball Valve.
Structure: Floating Ball Valve.
Type: Floating Ball Valve.