Examples of using The height and width in English and their translations into Slovenian
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Computer
-
Official/political
-
Programming
Subtract 1 inch from the height and width.
Set the height and width to the desired dimensions in inches.
Under Scale, enter identical values in the Height and Width boxes.
Visually reduce the height and width of the walls through a dark shade;
On the Size tab, under Scale,enter the percentages of the current height and width that you want to resize to, in the Height and Width boxes.
The Height and Width settings are always the dimensions of an unrotated table.
Shows or hides the rulers for the height and width of the currently selected sheet of paper.
The height and width of each letter was 5 times the thickness of each line.
The height and width of the head are slightly less than half its total length.
It can be seen that it will take into account the height and width of a sport radial motorcycle tire as a whole.
The height and width of the window plays an important role when choosing a textile design for it.
Lock aspect ratio- Select this check box to keep the Height and Width settings in the same proportion.
The height and width of the resulting stain should fully comply with the stated in the instructions.
There will also be minimum requirements for the height and width of packs, which will mean that some types of pack will disappear.
The height and width of the door opening must be measured taking into account the gap(10 -15 mm) between the door frame and the wall.
There will also be minimum requirements for the height and width of packs, which will mean that some types of pack will disappear.
The height and width are identical to the QSFP form factor enabling system designers to achieve identical system port count densities for QSFP28 or QSFP-DD based designs.
In order to transport on public roadways with limited restrictions, the height and width of MOSS fall within roadway maximum limits of 8'-6”(259cm).
Initially, the height and width of the door opening are measured taking into account the existing curvature.
When choosing a canvas, you should proceed from the following parameters- the height and width of the box, as well as the similar dimensions of the glass product itself.
Under Scale, in the Height and Width boxes, enter the percentage of size that you want, relative to the movie's original size.
Measure the height and width of your gate opening,and then cut your lattice sheet to that size, minus about 1/2 inch on each side.
When you change the Height and Width settings under Size and rotate, the proportional Height and Width settings under Scale change accordingly.
When you change the Height and Width settings under Scale, the exact measurement Height and Width settings under Size and rotate change accordingly.