Examples of using Friction force in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Comfortable, flexible, good friction force Wrist Brace.
Analysis of the road surface shows a defined pattern and friction force.
low friction force, low start pressure.
The friction force of the steel thread cuff entering the workpiece is obviously increased.
decreasing the inevitable friction force.
The friction force and the kinetic energy of the machine is made eccentric to rotate
reduction of surface tension lead to the decrease in friction forces of Si(100) and DLC.
When the screw is tightened, the friction force can not loosen the screw,
which is transferred via the friction forces to the torsional movement of the cantilever.
When the screw is tightened, the friction force can not loosen the screw,
it will produce a very large friction force in the work.
UniCarriers's patented 4-point Friction Force chassis automatically increases the drive wheel pressure to enhance traction in all conditions.
the locking edge deformation, the friction force to.
Blisters occur due to an intense and continuous friction forces applied across the skin of your foot such as when skin rubs against the shoe,
they measured an increase in friction force with a sensitivity in the tens of piconewtons.
The friction force, the correct application of forces
the locking edge deformation, the friction force to overcome the locking screws to screw side.
Two different phases are clearlyresolved in friction force image, while bare topography does not provide conclusive information on the sample composition
penetration depth, friction force) and video microscope observations.
The friction force of the steel wire threadinsertsentering the workpiece is obviously increased-the rocker of the hand-held spannerdoes not move,
the locking edge deformation, the friction force to overcome the locking screws to screw side.
increasing friction force, while the passive shaft is processed by grinding pin, which does not
increasing the friction force, easily lead to lock,
to quantify parameters such as friction force and adhesive strength,