Examples of using Network access server in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
RADIUS clients are network access servers or devices.
Enable EAP as an authentication protocol on the network access server.
Configure network access servers as RADIUS clients in NPS.
The NPS proxy is configured by adding each network access server as a RADIUS client.
Under Type of network access server, select Health Registration Authority, and then click Next.
When a connection is made, the remote access client negotiates the use of EAP with the network access server.
In both cases, these network access servers must meet the following requirements.
The Cisco AAA server sends the network access profile to the network access server the switch, AP, or router.
A network access server(NAS) is a device that provides some level of access to a larger network. .
In this configuration, the network access server is only a pass-through device.
Network access servers that provide remote access connectivity to an organization network or the Internet.
Used to designate the vendor of the network access server that is requesting authentication.
The network access servers must block the client from sending IP packets from port 68 to the network. .
In addition, there are filtering features that the network access servers should support to provide enhanced security for the network. .
A network access server running as a stand-alone server
In addition to configuring a new RADIUS client, you must also configure the network access server so that it can communicate with NPS.
This allows the network access servers, which create Access-Request messages based on information they receive from access clients, to forward messages to the NPS proxy.
An advantage of using EAP-RADIUS is that EAP types do not need to be installed at each network access server, only at the RADIUS server. .
you configure network access servers, such as wireless access points
which tells NPS where to send the messages it receives from the network access servers.
This configuration step allows the NPS proxy to receive messages from the network access servers and to communicate with them throughout authentication.
If the type of network access server is set to Health Registration Authority,
If you specify a network connection method, NPS evaluates the network policy only if the connection request originates from the type of network access server that you specify.
The following illustration shows the path of an Access-Request message from a network access server to a RADIUS proxy, and then on to a RADIUS server in a remote RADIUS server group.
If the type of network access server in connection request policy
with information that allows the network access server to communicate with NPS servers. .
After the Cisco AAA server receives the connection request from the network access server or router, the Cisco AAA server requests statement of health(SoH)
with information that allows the network access server to communicate with NPS servers. .
you are configuring NPS to receive RADIUS Access-Request messages from either a network access server or a RADIUS proxy.