Примеры использования Network access server на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Configuring network access servers.
On January 7, 2009, Cloud Engines unveiled Pogoplug network access server.
Install and configure network access servers(RADIUS clients).
On January 5, 2010, Iomega announced their iConnect network access server.
Install and configure network access servers(NASs) as RADIUS clients.
When a connection is made, the remote access client negotiates the use of EAP with the network access server.
In both cases, these network access servers must meet the following requirements.
The Cisco AAA server sends the network access profile to the network access server(the switch, AP, or router).
Configure network access servers as RADIUS clients in NPS.
The NPS proxy is configured by adding each network access server as a RADIUS client.
The network access server then forwards the EAP message to the remote access client.
For wide area network(WAN) environments, network access servers should provide the following.
The network access servers must block the client from sending IP packets from port 68 to the network. .
It can be used with for various NAS(Network Access Server) devices and programs.
Network access servers that provide remote access connectivity to an organization network or the Internet.
Enable EAP as an authentication protocol on the network access server. For more information, see your network access server documentation.
A network access server(NAS) is a device that provides some level of access to a larger network. .
In addition, there are filtering features that the network access servers should support to provide enhanced security for the network. .
A network access server running as a stand-alone server or as a member of a workgroup does not support EAP-TLS.
This TLS channel helps prevent an attacker from injecting packets between the client and the network access server to cause the negotiation of a less secure EAP type.
On the RADIUS proxy, the network access server is configured as a RADIUS client; and on each RADIUS server, the RADIUS proxy is configured as a RADIUS client.
An advantage of using EAP-RADIUS is that EAP types do not need to be installed at each network access server, only at the RADIUS server. .
The user or machine sends a request to a Network Access Server(NAS) to gain access to a particular network resource using access credentials.
Configure the physical RADIUS client, such as the wireless access point or authenticating switch,with information that allows the network access server to communicate with NPS servers. .
When you use NPS as a RADIUS server, you configure network access servers, such as wireless access points and VPN servers, as RADIUS clients in NPS.
Configure the physical RADIUS client, such as the VPN server or dial-up server, with information that allows the network access server to communicate with NPS servers. .
After the Cisco AAA server receives the connection request from the network access server or router, the Cisco AAA server requests statement of health(SoH) data from the client by sending an EAP-Type Length Value(EAP-TLV).
When you add a RADIUS client to the NPS configuration through the NPS snap-in or through the use of the netsh commands for NPS,you are configuring NPS to receive RADIUS Access-Request messages from either a network access server or a RADIUS proxy.
The network access profile contains the information that instructs the network access server whether to allow full access, restrict access, or deny access to the client computer.
When you configure a network access server(NAS) as a RADIUS client in the NPS snap-in, the RADIUS client forwards connection requests from access clients to the NPS server for authentication, authorization, and accounting.