Примеры использования Relative error на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
The relative error in its determination is±4.1.
Maximum permissible relative error of-± 25.
Basic relative error- no more than 3.
Your answer will be checked with the absolute or relative error 10- 4.
Relative error under rough test: no more than±0.25%.
Maximum permissible relative error of timer is less than± 0,05.
Relative error of results of pressure measurement at the container bottom,%.
It is shown that in the worst cases(rather rare) the relative error is less than ten percents.
Permissible relative error limit- no more than±3.
In the present investigation the simulation error- mean relative error(δrel)- amounted to 12.
Basic relative error of measurement of voltage.
For comparison, note that the straightforward implementation via the formulas of the discrete Fourier transform has the relative error[math]O\epsilon N{3/2.
Basic relative error of measurement of frequency- 0.5 Hz.
For these variables, the divergence between calculated andexpected errors was higher and relative error inferior to the highest limits fixed in the EU.
Permissible relative error limit- no more than± 0,01 seconds.
Table with processing results, with nuclide name(Nuclide column), nuclide activity in units, which have been set usingUnit context menu command(Activity(…) column), relative error of activity in% Error,% column.
Limit the relative error of measurements of weight- no more than± 3.
In many cases, it is more natural to consider the relative error| Δ x|| x|{\displaystyle{\frac{|\Delta x|}{|x|}}} instead of the absolute error Δx.
The relative error of coulometric determination does not exceed 2.
From the responses of these filters the best one was chosen and we calculated the relative error of measurement of non-linear characteristics of the circuits of the bell pulse duration of 100 ns.
The relative error in the reference time shall be less than 10-5.
In most of cases, the analysis of distribution of relative error proves a very high quality of information on the revenues, taken from two accessible sources.
The relative error in measuring the force pushed home- no more than± 5.
The main relative error of heat flux density-± 6%;
The relative error in measurement within the predetermined pressure range does not exceed 30.
Outside the main relative error in the measurement of the DC voltage-± 3%;
The relative error of the Cooley-Tukey algorithm is bounded from above by[math]O(\epsilon\log N)/math.
Outside the main relative error in the measurement of the AC sine wave, 50 Hz-± 3;
Basic relative error of measurement of amplitude, velocity and acceleration- no more than± 5,0%;
In this case, the relative error introduced by assuming a fixed end-point pH is negligible.