Примери коришћења Desired height на Енглеском и њихови преводи на Српски
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
The desired height in pixels.
Press in the post carrier to the desired height.
Crochet shaft at desired height without increasing.
Now you can build a wall to the desired height.
After reaching desired height over all stitches a row of right stitches work.
Shorten the offending trunk shoot to the desired height.
First you need to climb to the desired height, and then tighten the tool on the rope.
After about 81 rows,the ceiling has reached the desired height of 90 cm.
They should be extended to the desired height, not forgetting to display a concave shape.
The carriage is fixed motionless on the axis after it is set to the desired height.
A stalk will never grow to the desired height if there is not enough room for it.
The equipment allows you to lift the desired item to the desired height.
When the hedge reaches the desired height, the upper part is also subjected to severe pruning.
The trunk itself,if it has already reached the desired height, cut to branching.
Repeat until you reach the desired height of the purse, then finish the work and trim the thread.
Repeat the pattern, starting from the 1st row, to the desired height of the braid.
Once the desired height of the arm ball has been reached, once on both sides three stitches are chained off.
In this case, you can raise the car to the desired height without a variety of jerks.
Make several stitches andknit a few rows until the seam reaches the desired height.
When the basket has reached the desired height, we use the bend for the edges of the tubes and fix it with paper clips.
These devices are designed to lift heavy loads and fasten them to the desired height.
Currently, devices are forced to rise slowly to the desired height, taking advantage of their small maneuverable engines.
If the tube is finished, take the next one andcontinue until the craft does not reach the desired height.
The device itself gradually raises the car to the desired height, while it rolls under him.
When the screen is installed,you will only have to lower the legs by scrolling them to the desired height.
Then cut this roll to the desired height- the height of the toilet paper is already very well suited for a DIY crown of this kind.
And then horizontally"snake" lay between them thin rods to the desired height of the fence.
If the length of the legs is not enough to be installed at the desired height(up to the level of the ladder), additional footstools of strong materials are fixed.
When this happens, the pressure in the working cylinder is released, andthe load is lowered to the desired height.
When the plant reaches the desired height, remove the growing point and form of strong shoots a beautiful crown, and only then remove the leaves from the main stem.