Examples of using Basic disk in English and their translations into Greek
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Official/political
-
Computer
For example, you need to look at basic disk.
To convert a basic disk to a dynamic disk: .
Exe while the disk remains a Basic disk.
Partitions on the Basic disk are available immediately.
Change a Dynamic Disk Back to a Basic Disk.
Change a Basic Disk into a Dynamic Disk. .
You must set the disk focus before you manage a basic disk.
Before you change a basic disk to a dynamic disk, note these items.
Basic disk storage uses partition-oriented disks. .
In Windows, you can convert a Basic disk to a Dynamic disk. .
On a basic disk, selecting a volume also gives the corresponding partition focus.
Use the convert dynamic command to change a basic disk into a dynamic disk. .
On a basic disk, if you select a volume, the corresponding partition is put in focus.
You can use Diskpart to convert a dynamic disk to a basic disk.
The basic disk can be a data disk or system or boot drive.
Exe to extend a simple volume on a Dynamic disk that was originally created on a Basic disk.
The basic disk can either be empty or contain either primary partitions or logical drives.
Back up all the data on all the volumes on the disk you want to convert to a basic disk.
A basic disk contains basic volumes(primary partitions, extended partitions, and logical drives).
If your hard driveis formatted as FAT32, change the hard drive to an NTFS file system basic disk.
A"Stop 0x0000007B" error message occurs when you convert a basic disk that contains the boot partition to a dynamic disk. .
You must first delete all dynamic volumes on the disk, andthen convert the dynamic disk back to a basic disk.
The disk may be a basic disk or a dynamic disk but the disk must not contain any valid data partitions or volumes.
The new partition or logical drive is created andappears in the appropriate basic disk in the Disk Management window.
Additionally, the disk must be a raw basic disk that has unallocated space that is greater than or equal to the capacity of the primary system disk. .
If you try to extend a simple volume on a Dynamic disk that was originally created on a Basic disk, you receive the following error message.
For additional information about dynamic disk and basic disk storage, click the following article number to view the article in the Microsoft Knowledge Base.
INTRODUCTION This step-by-step article describes how to use the Windows XP Disk Management snap-in to configure a basic disk and prepare it for use.
To create a new partition,right-click unallocated space on the basic disk where you want to create the partition, and then click New Partition.
For additional information about how to convert a basic disk to a dynamic disk and how to convert a dynamic disk back to a basic disk, click the following article number to view the article in the Microsoft Knowledge Base.