Examples of using Ping command in English and their translations into Hungarian
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Programming
-
Official/political
-
Computer
Using the ping command.
The Ping command uses this type of ICMP message.
Used by the ping command.
The ping command sends ICMP echo requests to the server….
By using the ping command.
Ping command to the base station ping. .
One way to do this is with the ping command.
To use the ping command, follow these steps.
To test connectivity, use the ping command.
The syntax for the ping command in this case is.
To test the connection, use the ping command.
For example for the ping command use/bin/ping Profiles.
The best tool for this task is the ping command.
How to use the Ping command to troubleshoot network.
The following example shows ping command output.
If the ping command fails to start, the router is most likely in recovery mode.
The following are some results of the ping command.
You can use the Ping command to test both the computer name and the IP address of the computer.
Starts a terminal window with the ping command to a remote computer.
The client computerscan successfully contact the server by using the ping command.
After the black window appears, enter the Ping command/ Network address of the router.
To use the ping command to test connectivity between two computers on the network.
If there is an error in the delivery to the destination, the ping command displays an error message.
The ping command displays whether the destination responded and how long it took to receive a reply.
It's really simple,just always show you a realtime value of a ping command to a specific destination.….
Using ping The ping command helps to determine if a device on a network is responding by IP address.
After configuring the TCP/IP communication protocol, you can use the ping command to determine whether your PC has successfully connected to the router.
If the client hardware appears to be prepared and functioning properly, verify that it can contactother computers on the same network by using the ping command.
If you are having connectivity problems,you can use the ping command to check the destination IP address you want to reach and record the results.
To verify whether a client has basic TCP/IP access to the DNSserver, first try contacting the preferred DNS server by its IP address by using the ping command.