Examples of using Pressure difference in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
The pressure difference, p2- p1, is given by.
Optional simple accessories such as temperature control and pressure difference alarm.
Calculate the pressure difference between the two ends of the pipe.
Sapphire windows are highly tolerant of extreme tepermature and pressure differences.
This reduces pressure differences between the Arctic and mid-latitudes, weakening jet stream winds.
People also translate
The thick wall of theBüchner flask provides it the strength to withstand the pressure difference while holding a vacuum inside.
The pressure difference between the higher pressure air below the floor and lower pressure atmosphere above the floor produced lift, causing the hovercraft to float above the surface.
Most of the exhaust gasesare discharged through the exhaust ports due to the pressure difference between the interior of the cylinder and the outside of the gas ports.
Usage: after air compressor blowing-in, making the powder material inside tank turn fluid status from solid status,and then unload the material inside tank into designated spot by using pressure difference outside tank.
The hot-water tap which is led from the overflowpipe must be lower than the cistern so that the pressure difference between the cistern and the tap causes the water to flow out of the tap.
When the filter inlet and outlet pressure difference≥ 0.5kgf/ cm2, indicating that the filter device has been blocked by mechanical impurities, should be promptly cleaned or replace the filter, the filter cylinder should also be cleaned.
High pressure pump is mainly to addpressure of the inlet water into a certain standard so that the pressure difference will be enough for the Reverse Osmosis need.
When the two sides of the membrane are subjected to different pressures(or forces), the membrane moves towards the side with lower pressure, causing the displacement of its center in a certain relation to the pressure difference.
However, if we tilt the pipe to avertical position(similar to turning on a voltage source), a pressure difference is created(similar to a voltage difference) and the water begins flowing through the pipe.
Throttle Valve, the hydraulic flow area can only be changed according to external instructions such as manual operation, mechanical or electronic control,so the actual flow through the valve is affected by the pressure difference across the valve.
If we were to remove the spiritual energy from his body using traditional palm-to-palm method,it might cause a pressure difference in the spiritual energy in his body, and this could potentially result in his meridians rupturing.
Urey had predicted a vapor pressure difference between the molecular hydrogen(H2) and of a corresponding molecule with one hydrogen atom replaced by deuterium(HD) and, thus, the possibility of separating these substances by distillation of liquid hydrogen.
At this time, all pulse valves of the dust collector do not work, the pressure of the air bag is rapidly reduced to zero,the cylinder is closed, the pressure difference of the dust collector continues to increase, and the ventilation volume rapidly decreases;
Integrated combination valve configurationbig flow external oil core, pressure difference is small, high separation efficiency, maintenance, maintenance is convenient, with high performance oil filter, oil security is clean, extend the life of the compressor internal parts.
The poppet moves under these two pressures and the spring force and stops at the equilibrium position, so that between these two pressures, the difference, that is, the pressure difference across the throttle valve, maintains the constant-spring pressure. .
The pneumatic diaphragm pump in the mine USES the pressure difference in the air chamber to alternately produce the suction liquid pressure and the positive liquid pressure in the liquid chamber, and the control valve switch can ensure the positive flow of the liquid.
Airfoils are designed so that the flow over the top surface is faster than over the bottom surface, and therefore the average pressure over the top surface is less than the average pressure over the bottom surface,and a resultant force due to this pressure difference is produced.
The back surface of the abrasive belt is provided with a precision elastic pad and a wear-resistant pad,which forms the pressure difference and the abrasion reducing effect, thereby ensuring the deburring precision(2M53130 is a precision slotted rubber roller).
Once the pressure difference between the two main pipe up to 3.5~ 4.5Mpa, the piston IS to overcome the spring force to the right(left) movement, so that the travel switch contact closed, the signal to control the solenoid valve to switch, the reverse movement to complete a cycle of work.
In the late 1950s, engine vacuum was again applied to operate the first intermittent wipers, in which mode the wipers were powered by air rushing into the vacuum stored in a small canister,and stopped when the pressure difference between the outside air and the canister became too small to power the wipers.
Two-way hydraulic flow control valve, referred to as two-way flow valve,its flow area can change with the pressure difference between the two connection side of the flow valve within a certain range, to keep the flow through constant, so it is also known as pressure compensation(pressure-compensated).
When the tricone bit iadc 117 is working the teeth on the main cone and the secondary cone of the cone are crushed by the formation while being subjectedto the reaction force of the formation causing the high frequency sloshing of the cone along the axial direction and the pressure difference between the inside and….
Mineral water equipment is powered membrane pressure difference on both sides, on the basis of the mechanical sieving principle of separation of a solution, using pressure is 0.2 MPa, 0.6MPa, usually separate aperture 1 nm- 0.1 mu m, can be widely applied in the separation, enrichment and purification of matter.
If the flow rate≥250L/ min of lubrication system which will transfer the lubricating oil from the steam heating reservoir,the pressure gauge is mounted on the dashboard to measure the pressure difference of cooler, all of the main parts for≤125L/min are mounted on the lubricating oil reservoir as the overall structure.
When the Tricone Bit iadc 117 is working, the teeth on the main cone and the secondary cone of the cone are crushed by the formation while being subjected to the reaction force of the formation,causing the high-frequency sloshing of the cone along the axial direction, and the pressure difference between the inside and the outside of the bearing chamber due to the axial sway.