Examples of using Melt in English and their translations into Marathi
{-}
-
Ecclesiastic
-
Computer
Melt flow rate is too high.
The oil should completely melt.
Not melt or affected by needle heat.
Filament is Orderly wrapped and Melt well.
YM53 Hot melt transfer coating and laminating m….
Filter media: Polypropylene melt blown membrane;
Low Melt Bags for Rubber Seals and Shock Absorb….
Well, here are a few more that will melt your heart!
HZM- 1300 hot melt and solvent board laminator.
HPP series of cartridge adopt polypropylene melt blown membrane.
Deformity) 1、Melt flow rate is lower, and bad flowability.
Lower injection temperature and pressure 1、Select higher melt flow rate material.
Their melt can become a reason for the increase of the fault.
True springs may also,being dependent on rain or snow melt. be polluted.
It has a melt temperature of 250 °F and can be laundered in small sections.
Before printing, the frosting printing melt resisting agent is blended with an adhesive.
Hot melt tapes exhibit significantly higher adhesion than acrylic tapes.
And it is difficult when they are so fit they almost melt their skinny jeans!
The mountains melt like wax at the presence of Yahweh, at the presence of the Lord of the whole earth.
Once the powder has been applied it is passed through a curing oven where the particles melt and fuse together and adhere to the components surface.
For this one must melt stearin with small to medium heat, add triethanolamine and simmer for ten minutes.
Heating box total length is 4.4m, relatively extend heating time,avoiding over high temperature melt the sheet, at the same time making better secondary foaming effect.
The mountains melt under him, and the valleys split apart, like wax before the fire, like waters that are poured down a steep place.
The glare and heat of the flashlights can melt metal and the bridal makeup should be up to the task.
Frosting printing melt resisting agent is prepared from ferric oxide, talcum powder, clay, etc., and is ground with a ball grounder, and its fineness is 350 meshes.
Do-it-yourself(DIY) home cookers arebetter to start from easier brewing steroids, with less melt point and commonly seen solvents and carrier oils.
Glueing technology by means of hot melt and reactive American Nordson daubing system hot melt adhesives(PUR).
Thermal transfer series photoluminescent self-adhesive film is made from high quality strontium aluminate luminescent pigment whichis manufactured by Minhui mixing with hot melt.
Construction is convenient, the melt method can operate in four seasons, joints are reliable.