Examples of using External controller in English and their translations into Russian
{-}
-
Official
-
Colloquial
AVR Attiny13 was used as an external controller.
External controllers support, through either the Android native way or input method.
The sound level can be reduced by an external controller or via a floating contact.
Optionally, a maximum of 3 additional tones can be switched to using an external controller.
An external controller also makes it possible to define priorities for given heat source operation.
Module 223e is designed to process signals coming from an external controller 222e.
These inputs need to be controlled by an external controller, such as a solar inverter, or a home energy management system.
Optionally, a maximum of 3 additional tones can be switched to by using an external controller.
In this case, the players have to watch the external controller, which will take the card and chip count.
CC3020 General description 4 Step"Regeneration start” In case the conductivity remains too high, eventually the regeneration will be started via an external controller.
Scientific management by post-graduates:"internal" and"external" controllers// Proceedings of Saratov University.
It is impossible to obtain permission for IP and other types of small entrepreneurs, so the organization is obliged to have the form of LLC andthe license of CySec external controller.
Regeneration start Via this output, it can be indicated that an external controller has to activate a regeneration.
If a regeneration is started via the external controller than the CC3020 will be switched to the step“regeneration” via input“regeneration detection”.
The board contains a 25 MHz reference oscillator and requires an external controller to control the registers.
CC3020 General description 5 Step"Regeneration” In case the external controller has started the regeneration and also indicates this via the input“regeneration detection, the step“Regeneration” will be active.
This is the reason why PERCo proximity card readers can be simultaneously used with external controllers of different types.
Forced OFF" mode In"Forced OFF" operation mode, the external controller can be set to trigger the system to deactivate the operation of the outdoor unit compressor and the electrical heaters.
The flush valve is closed Via the input“Regeneration”(LP) it is monitored whether the external controller has actually switched to regeneration.
All other BASIC/C-programmable products including boards, external controllers, and development systems("NON-MODULE PRODUCTS"), such as the DS1101, are normally shipped with a BASIC/C APPLICATION pre-loaded.
In addition, Analog Heat has 3 MIDI-IN/Out/Thru connectors and 2 jacks for external controllers, such as expression pedals.
Hard Disk Sentinel for DOS allows to view the temperature and health information for IDE andS-ATA hard disks connected to motherboard or external controller cards.
Besides, Analog Heat offers 3 jacks MIDI in/out/thru and 2 jacks for external controllers such as an expression pedal for example.
In external multiplex mode, an external trigger signal is required andthe timed sequence must be coordinated by an external controller.
The instrument ensures basic MIDI support, USB,has all the necessary connectors for external controllers, such as pedals and, of course, separate stereo outputs.
The following values are monitored:- Input“regeneration detection” Step"Regeneration wait” This step only appears in case the external controller has not started a regeneration within 960 seconds.
Regeneration busy The input function“Regeneration detection” is used to verify whether the external controller has activated the installation in“Regeneration”.
You can also connect an external tape ribbon controller.
USB 1.1 FS(device) controller with external serial interface for I/O devices;
The data handling relating to the web services on this site takes place at the offices of the owner and the external data controller.