Examples of using Fault detection in English and their translations into Russian
{-}
-
Official
-
Colloquial
Fault detection criteria.
LFT for Comprehensive Line Fault Detection.
Fault detection criteria.
How often do you perform fault detection on pipelines?
Maximum fault detection(lumps/neckdowns) at increased line speeds.
How often do you perform fault detection of the pipelines?
It is the ideal product for our power cable fault detection.
Software for fab-wide fault detection and classification FDC.
Flexible signal analysis for precise fault detection.
It can do high impedance fault detection directly without burning.
Several detection methods commonly used in cable fault detection.
Sophisticated fault detection systems ensure higher reliability.
MA output provides repeatable indication of flow rate and fault detection TD2.
NaCl uses software fault detection and isolation for sandboxing on x86-64 and ARM.
Avoiding failures through redundancy and/or fail-safe behavior and fault detection.
A fault detection by the sender is registered only by the rear Climatronic control unit -E265.
You can send us a scoop produced by our company for fault detection by any convenient carrier.
A fault detection by the sender is registered only by the Climatronic control unit -J255.
Among the cable tests, the high voltage bridge method is a frequently used fault detection method.
Cable Test Van,also known as cable fault detection car, is a comprehensive set of cable fault detectors.
This connection can be used to exchange commissioning information,diagnostic data, or for fault detection.
The bridge method is a traditional cable fault detection method that can achieve very desirable results.
The fault detection is active not only while the anti-theft alarm is primed, but also as soon as the convenience system central control unit -J393 is active.
It is the comprehensive software for diagnostics, fault detection, mechanical and electronic work and creating offers.
This detection method is very convenient, has a very high detection accuracy, andis a frequently used cable fault detection method.
Additional features include the power supply to the sensor, line fault detection, and the collective error message via power bus.
The fault detection is active not only while the anti-theft alarm is primed, but also as soon as the convenience system central control unit -J393 is active.
The method of applying low-voltage pulse emission in cable fault detection should inject low-voltage pulses into the damaged line.
HZ-901S intelligent energy meter calibrator is designed for the power system on-site inspection of high-voltage power grid metering device operation and fault detection.
Power engineers are now conducting extensive fault detection of the major components of the turbine unit, based on which further works will be performed.