Examples of using Insulating material in English and their translations into Russian
{-}
-
Official
-
Colloquial
Piping insulating material unit side.
Seal with putty and insulating material.
Piping insulating material field supply.
When using pipe with super insulating material.
Vacuum insulating material+ edge strip 32.0 mm.
As a heater We use return a solid insulating material MICROGUARD.
Putty or insulating material(produced locally) 1.
The middle layer between the frame andthe wall is filled with insulating material.
By detecting SF6 insulating material inside the….
The insulating material and the method of insulation shall be identical;
A Refrigerant pipe and insulating material Procure locally.
Pipe insulating material polyethylene foam, 6 mm thick.
Wrap the sealing material(Small)(9)around the joint insulating material(6) 7.
Mineral fibre insulating material(MIN) with heavy film inserts.
The side walls and the bottom are double-walled andequipped with highly insulating material.
Try to remove the insulating material from the tool when it is still warm and soft.
As cork's thermal conductivity is very low,it is also used as an insulating material.
Apply insulating material(I) until drain piping connecting part, as shown above.
The external body panels adjacent to the door apertures shall be covered with insulating material.
If the insulating material is foamed in situ, the production date is the date of application.
In high humidity environments, metal supports must be insulated using adhesive insulating material.
After the leak test, apply insulating material tightly so that there is no gap.
Insulating material is not placed around any part of the Radar transmitter including the antenna flange.
Door panels shall be made of insulating material or insulated from the trolleybus body.
Piezoelectric ignition coating of the combustion chamber from vermiculite,a high performance insulating material.
Do not place insulating material around any part of the Radar transmitter including the antenna flange.
A jacket and an inner shell with an intermediate layer of solid thermally insulating material(e.g. solid foam);
The insulating material obtains this label if the binder components pass the safety testing.
Tighten the section where the piping insulating material and the joint insulating material(6) overlap.
Apply insulating material(I) until drain piping connecting part, as shown in the upper right illustration.