Examples of using Lead wire in English and their translations into Russian
{-}
-
Colloquial
-
Official
Find the lead wire.
Lead wire for stimulation 1 pc.
Check the winding or lead wire for breakage;
Lead wire for EMG electrodes 3 pcs.
N 510/FB with additional lead wire support.
Lead wire for CIG electrodes 2 pcs.
Loosen terminal screw Terminal block Lead wire.
Lead wire for injection control 1 pc.
When pulling out the sensor, do not pull it by the lead wire.
Lead wire for stimulation with 6P4C socket 3 pcs.
Pair of high quality Tens electrode lead wires.
Lead wire 2 electrode gas discharge tube 5.5*4mm.
It would take me at least five minutes to find the lead wire.
Lead wire for polygraph signal registration 3 pcs.
Make sure to place the lead wire in opposite side of the arm.
Lead wire for polygraph EEG registration 1 pc.
You can connect indoor/outdoor lead wire without removing the front panel.
Lead wire for stimulation and myogram tracking 1 pc.
A device was affixed on the head and the lead wire terminated at the actual intention point.
Each lead wire ends with two 3.5mm stud connectors.
The fastening part of the bushing terminal is loose or the nose of the lead wire is slippery, etc.
The aluminum shell and lead wire could be manufactured by custome-made requirement.
Design Features: It is a variation of 1-5 Model with a fixed threaded connection and lead wire.
The defects such as blisters orcracks are left in the manufacture of the lead wire of the cable, and the cable is also damp.
It can be installed in the bottom of the car as shown oryou can install it the same way as lead wire.
When opening the knock out hole, be careful not to damage fan motor lead wire with the steel plate cut off. Refer to Fig. 16.
When returning the electric box cover, be careful not to pinch the fan motor lead wire.
The ignition system consists of a Vulcan electric fusehead, with lead wires, of the type commonly used for igniting pyrotechnic substances.
Design Features: It is a variation of 1-5 Model with a spring loaded fitting and lead wire.
The significance of measuring the DC resistance is to investigate the winding insulation and current loop connection conditions, and can reflect the winding quality of the winding, the winding turn-to-turn short circuit,the winding strand break or the lead wire break, and the tap Faults such as poor switch and wire contact, in fact, it is also an effective means to judge whether the DC resistance of each phase winding is balanced and whether the voltage regulation switch is correct.