Examples of using The capacitance in English and their translations into Russian
{-}
-
Official
-
Colloquial
Generally, the capacitance is reduced.
I found problematic, but it is better to reduce the capacitance.
The capacitance of an"off"-state discrete PIN diode might be 1 pF.
If some components are broken, the capacitance value will decrease.
The capacitance for charging and discharging shall be calculated as follows.
If the capacitance is less than 0.05µF,the instrument cannot output normally.
With our systems, you can measure both the capacitance and the dissipation factor.
The capacitance increases with increasing device area and decreasing thickness.
It is easy to understand as the capacitance was being changed and this affected the tuning.
The capacitance between the cakes in parallel with the inductance also changes.
The capacitance test can also sensitively reflect the insulation condition of the capacitor impregnant.
A nearby object which varies the permittivity of the surrounding area will also vary the capacitance.
As the capacitance on one side increases,the other side decreases.
With our testing systems,you can even determine the capacitance and dissipation/power factor at variable frequency.
The capacitance C{\displaystyle C} between the two conductors is represented by a shunt capacitor C farads per unit length.
Mikrofaradometr D595- the four ultimate device for measuring the capacitance of the capacitors with tgδ not more than 0.03.
If the capacitance value is greater than 62, should be re-installed, dielectric loss failure, should re-clean the oil cup.
The capacitance remains practically unchanged throughout the operating life which is of particular interest for applications with tuning or detuning reactors.
In the oil-impregnated paper capacitor, the oil acts to fill, impregnate, andinsulate to increase the capacitance and dielectric strength.
Please make sure that the capacitance of test products is below the instrument rated capacitance. .
Measuring signal frequency: At present, many battery internal resistance measurements actually measure the impedance of the battery, while the battery is not purely resistive, butalso contains the capacitance.
In general, this ends up being defined by the capability of the control transistors, the capacitance of the lines carrying power to the cells, and the heat that power generates.
However, if the capacitance of the transformer is small, it is generally not displayed, and the cable capacity is relatively large, so the measurement cable is usually displayed.
After the oil cup is installed,first check the empty cup, the capacitance value should be 60± 2pF,the dielectric loss is less than 0.005%;
It was shown that the capacitance curves in these systems are generally parabolic with two minima, whereas three minima were found in sodium and potassium chlorides at relatively low temperatures.