Examples of using Time constant in English and their translations into Russian
{-}
-
Official
-
Colloquial
Opening time constant.
C: time constant, C 0 .2 sec.
Closing time constant.
C: time constant, C 0 .2 sec.
Clutch opening time constant.
C: time constant, C 0 .2 sec.
Clutch closing time constant.
Thermal time constant(s): 20-50 in air.
The damping can be individually set for each output by a time constant.
Measuring time constant sec. No more than.
In this case the last three beats are recorded with time constant of not less than 3 seconds.
Thermal time constant(s): 20-50 in air.
C3._.7 Limitation Limitation before applying the time constant±xxx…±xxx%; range.
Thermal time constant 79s in the static air.
Thermal time constant: 7 seconds cooling in air.
The drag force is often written Fdrag-γv;therefore, the time constant τ equals m/γ.
Clutch closing time constant for driveaway.
Time constant More detailed information can be found in the subsection"Response times" of the section"Technical data.
As the result, we calculated the time constant T 0.2sec and delay τ =0.12sec.
The time constant of this filter can be changed in C1.1.5.
Τice, 2 is the speed dependent time constant for slow engine torque response, s.
The time constant can be individually set for each output, the first line of the display and the density measurement.
Taking into account all above it is possible to suppose that time constant is in range of 10â 15â 10â 14Ñ.
Sets a time constant to increase signal stability.
Registration of temperature field dynamics was carried out using infrared thermograph FLIR A600(Sweden) with 8 ms sensor time constant and recording speed of 50 frames per second.
At the global level, the time constant for fundamental energy transitions has been on the order of 50 years.
In the case when there is significant primary resistance or switch resistance or both(total resistance R, e.g. primary-coil resistance plus a resistor in the emitter,FET channel resistance), the Lp/R time constant causes the magnetizing current to be a rising curve with continually decreasing slope.
Both the speed dependent time constant and the dynamic and direct torque division are mapped as function of speed.
The time constant corresponds to the elapsed time until 67% of the end value has been reached according to a step function.