Examples of using Minimum thickness in English and their translations into Serbian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
The minimum thickness is 10 mm.
High-quality plywood with a minimum thickness of 20 mm;
Minimum thickness of the layer should be 15 mm.
Parquet must be of good solid wood, minimum thickness of 2 mm.
Set the minimum thickness of the filling.
It can be in the form of a fabric cloth orPVC film of minimum thickness.
Minimum thickness Single, double boardFour-layer Board0.2mm.
With four centimeters of layer thickness you are just in the minimum thickness for underfloor heating.
Simple boards with a minimum thickness of 40 mm are suitable for the manufacture of all the tsarg.
MIL-T-27730A is a U.S. military specification(MIL-SPEC)that specifies a minimum thickness of 3 mils.
Such a device will allow you to get the minimum thickness of the cut, which means that waste is minimized, and the profitability of the sawmill will increase.
For a start, you will need to connect the goats with each other with a wide wooden board with a minimum thickness of 50 mm, and then fix the kitchen table on this base.
The minimum thickness of most boxes is 5mm, which is less than 1% of the box thickness and have no significant effect to the box mechanical properties.
Longitudinal stop is made of well-treated board with a minimum thickness of 25 mm and a width of at least 150 mm.
As a rule, for plaster, the minimum thickness is considered to be 5 mm, if the layer is made smaller, the coating will turn out to be of poor quality and will not last long.
What are its features, what types of floor it is used for, what is the minimum thickness of the layer, will be discussed in this article.
All that is required is to know the length and width of a premise, its height, in the corners,as well as the minimum thickness of a layer of fill, then our program will calculate for you the amount of material to fill a given differential heights.
If the concrete surface is considerably rough, smoothness could be achieved by using available materials with minimum thickness such as gypsum(plaster of Paris), cement mortar or epoxy resin, but it takes some time for these filling materials to become solid.
For drywall, the minimum solution thickness is 1 cm.
The composition has a gray tint and, depending on the variety,is characterized by a minimum layer thickness, which distinguishes it from other analogues.