Examples of using Safety function in English and their translations into Slovak
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
Automatic shut-off safety function.
The safety function is dependent upon the reliability of the components.
Which serves to fulfill a safety function.
Is by-passed and the safety function is performed via the SIL module.
Programmable electronics with safety function.
The safety function remains effective in the case of a component failure.
Furthermore AMV(E) 13 are actuators with safety function.
The safety function is dependent upon the reliability of the components.
Furthermore AMV(E) 33 are actuators with safety function.
When the faults occur, the safety function is always performed.
AMV(E) 23 SU(spring up) is an actuator with safety function.
The safety function must be checked by the machine controller at suitable intervals.
For existing lock cylinders with emergency and safety function.
If individual faults occur, the safety function always remains intact.
The aim is to investigatehow failure of a component will affect the safety function.
When a single fault occurs, the safety function is always performed.
The safety function must be tested at suitable intervals by the machine control system.
Automatic shut-off after 30 mins with double safety function.
A safety function is fulfilled by the protection against overheating when turned on without any water.
An error between checks can cause the safety function to fail.
Safety function of the safety component, if not obvious from the description.
After the fault is rectified, the safety function is automatically reset.
The safety function is temporarily jumpered when the material is transported through the protective field.
When individual faults occur, the safety function must always be preserved.
A safety function of the rider clothing is not required due to the intelligent assistance systems.
Since the safety function runs decentrally in the drive, an extremely short maximum fault detection time of 8 ms is guaranteed.
For each safety function which is run by a safety-relevant part of a control system, a required performance level(PLr) must be defined and documented.