Examples of using Etching process in English and their translations into Spanish
{-}
-
Official
-
Colloquial
Matters needing attention during the etching process.
However, there are more etching processes and more details.
Etching process and process control of PCB.
Verifying Coating and Etching Processes.
The etching process is then completed by a complete automated pipeline.
Silicon is machined using various etching processes.
The etching process implemented together with B&R is managed entirely by a Power Panel.
Each copper charm is handcrafted using an etching process.
A dry etching process is applied to high-end ultra-fine patterns of semiconductor photo masks.
Photogravure is a true continuous tone photographic etching process.
However, the yield andproductivity of the dry etching process is much(15 to 20 times) lower than the wet process. .
The built-in LED light ensures optimum visual control of the polishing/etching process.
While in some instances a dry etching process without surfactants can be used, such a process is not suitable for LCD panels measuring more than 1 m x 1 m.
Different precision: Generally speaking,the precision of the etching process is higher.
While appearing similar in the photolithography,diffusion and etching processes, the approach of Andrews had a fundamental flaw: it involved the complete removal of the oxide layer after each diffusion.
I was frustrated with trying to control the circuit board etching process.
According to information from Japan, PFOS is used in an etching process of the piezoelectric ceramic filter which is used as a bandpass filter at intermediate frequency in two-way radios for police radio, FM radios, TV, Remote Keyless Entry for Cars, etc. Annual PFOS usage is about 20 kg.
The crown piece is thinned through a chemical etching process, reducing it to just 0.5mm.
Made of 304 stainless steel,the Venus features attractive appearance with unique etching process.
High-precision weighing is a simple non-destructive method to verify coating or etching processes.
Rinse each tooth with water/air spray for 10 seconds(20 seconds for gel etch) to stop etching process.
Photosensitive polymer compounds called photoresists are used to mask circuit lines for the etching process.
It is a very complex task to develop dry etch processes that balance chemical and physical etching, since there are many parameters to adjust.
This subtractive manufacturing process uses etching lines to remove material.