Examples of using Substrate should in English and their translations into Spanish
{-}
-
Official
-
Colloquial
The substrate should consist of sand!
Any holes, cracks on the surface of the substrate should be pre-sealed by grouting mortar.
The substrate should be slightly darker.
Moisture content of substrate should not exceed 10%.
The substrate should be rich in nutrients.
At the same time, the substrate should remain the lower and upper layer.
The substrate should be feinkörning and dark.
If that is not desirable, the substrate should first be prepared with a white gesso.
The substrate should be moist but not wet, and relative humidity dropped to 40.
Live rock(transported moist in boxes) should be reported in kg; coral substrate should be reported as number of pieces since these are transported in water as the substrate to which non-CITES corals are attached.
The substrate should be primed with FESTGrunt.
In short: the substrate should always be moist, but not too much.
The substrate should be fine and not too bright.
The substrate should not be strongly compacted.
The substrate should always be kept slightly damp.
The substrate should consist of fine-grained, dark sand.
Which substrate should I use if I want to grow outdoors?
The substrate should be clean and free from dust and grease.
The substrate should be even, firm, clean and free of moisture.
Unreacted substrate should be colourless to very light green in appearance.
Unreacted substrate should be faint yellow to pink in appearance.
The substrate should be prepared per recommendations of adhesive selected.
The seedling substrate should be light, nutritious and neutral(ideally slightly alkaline).
To create this roughness, the substrate should be grit blasted or slurry blasted to SA 2.5(cleanliness)- or treated with a steel brush for small, non-critical applications.
Make sure that the surface treatment of the substrates should be clean, dry and coarse.
Bare substrates should be primed, according to substrate. .
The substrates should not be excessively degraded or contaminated.
Acetylated and thermally modified wood substrates should use standard Ardera and Eos colors.
The area in which foam is first separated from other substrates should be fully enclosed wherever possible and any significant emissions captured at that stage.
The substrate surface should be smooth.