Examples of using The stator in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Two components, the rotor and the stator.
Table 9 measurement of the stator of a connected line graph.
The stator is designed to encircle the periphery of the rotor.
Prepare a measurement record form for the stator and rotor circuits.
are connected to the stator.
With the shaking table to check the stator insulation resistance at 200 m above.
For DC Amp alternators, replacing the stator, diode or regulator may be required.
On the stator there are 64 armature windings that collect the variations of the magnetic flux.
However, some rotors carry permanent magnets, and the stator holds the conductors.
The stator windings are cooled by water flowing within stainless steel tubes embedded in the Roebel(stator) bars.
Just seen a certain vibration of the support of the stator and the gallows.
copper are situated in the stator.
Once assembled, they form the laminated cores of transformers or the stator and rotor parts of electric motors.
Since the phases are also spatially offset by 120°, the stator builds up a magnetic field that rotates with the frequency of the applied voltage.
In this latest video, he stuck 6 bar magnets on the board, and 2 horseshoes on the stator, and look at the result!
It is the relative motion between the stator and the translator in the generator which causes voltage to be induced in the stator windings.
makes retensioning the stator a simple, few minute process.
For a long pump service life: a temperature sensor installed in the stator checks the temperature between rotor
Normally, the rotor of an alternating current machine has a winding fed by DC(direct current) in order to achieve a rotating magnetic field in the stator.
For a long pump service life: a temperature sensor installed in the stator checks the temperature between rotor
reduce the rejection rate of the stator during transport.
it is important to determine the radial run out of the rotor inside the motor compared to the stator.
This group of induction machines includes electrical machines whose mode of operation is based on a rotating magnetic field in the air gap between the stator and rotor.