Examples of using Certain angle in English and their translations into Thai
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Sometimes when I catch my mom at a certain angle.
The wheel at a certain angle and under a certain load.
During sharpening device must be held at a certain angle.
Supplemented by a certain angle, the continual pipes are formed in the three-roll rolling machine.
Then they are sent to the forming machine in a certain angle.
Generally, typical ladder mounted at a certain angle, and occupies a lot of space.
Vertical state for the specimen, lower fixture rotates to left and right repeatedly at certain angle, until the.
Put the plant is not vertical, and at a certain angle(30 degrees), so that it takes root have a bend.
Principle of work: Tractor drives the harvester working, Digging shovel shovels soil at a certain angle.
An examination using X-rays projected through the body in certain angles to create cross-section images.
Not like ordinary punch machine, usually need to change and make a new sets of molds just for some certain angle.
On its beginning and ending, and it can form a certain angle to improve its leveling quality.
The Soft LED Module is ultra-thin, extremely lightweight, and the most flexible design shape, effect, any type, curved at certain angle.
To be able to saw off the workpiece at a certain angle with a standard handsaw have to buy special miter box.
The interlaced point of the warp and the weft is a structural form of a diagonal line at a certain angle on the surface of the fabric.
Tilt the device to form a certain angle of supply jets, adjusting them to easily change the overall composition.
Its surface is punched with oil apertures by certain angle and density.
Because most of the racks are at a certain angle, the raised part can block the sliding of the solar panels.
And I'm going to show you in a second, that the sine of theta- if this angle is a certain angle- it's always going to be 3/5.
The solar panels could be tilted at certain angle, leaving some gap from each side of the solar panels to meet the sunshine demands of crops.
Handmade forged axes are sharpened by the master at a certain angle for each type of work.
GLD series Coal belt feeder Summarize Belt feeder working principle The material in the silo enters the guide through the connecting section and falls on the steel wire tape When the tape is stationary the material finally stops moving by the internal friction force and forms a static accumulation at a certain angle….
But traces and prints are noticeable only at a certain angle, so I can not call it a disadvantage.
The workpiece is placed on the workbench, quick change, the torch can be adjusted up and down, left and right, and angle at a certain angle.
Successive flex after certain time at certain frequency and certain angle, check the bending resistance.
The testing method is put the shoe or the sole on the folding test machine to a certain angle and around a certain frequency folding test to measure the soles, and observe the changes in the number of post-soles.
The basic techniques are as follows: turn the boat to the angle you want to reach, change the position of the boat in the river, the most important thing is to keep the boat at a certain angle from the running water, and then back paddle, rather than towards the river bank.
The reader automatically run after the brake lever to unlock certain angle, automatically bring people through the gates;
LED display panel is composed of red, green and blue to produce various colours, but these three colours are made of different materials, the perspective is different, the spectral distribution of different LEDs are changed, these differences can be observed are called chromatic aberration. When viewing the LED from a certain angle, its colour changes. The human eye's ability to judge the colour of the real picture(such as the film picture) is better than that of observing the computer-generated picture.
JDB Copper Bearings is a special formulation of high strength copper-based body surface at a certain angle and density of embedded solid lubricant specially formulated by precision machining.