Examples of using Crankcase in English and their translations into Thai
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Best Quality Crankcase.
Diesel crankcase breather.
Prevent carbon buildups in crankcase.
Crankcase: Magnesium Alloy.
Automobile crankcase HPDC die.
Collect the oil and moisture from the crankcase.
Black Crankcase Vent Valve Audi.
The booster is lubricated by the oil in the crankcase.
Previous: Crankcase breather pipe OE 1192W0.
Standard Delivery with: Compressor standard motor and crankcase heate.
If the driver filled a fake in the crankcase, this situation is quite possible.
A crankcase is the housing for the crankshaft in a reciprocating internal combustion engine.
You may need to gently pry the power head crankcase up to break the seal.
Light plastic crankcase. Anti-freezing material is available, even works at minus 40 centigrade.
This includes oil pump outlet pressure and crankcase pressure not suction pressure.
On the crankcase there is a drain plug, which should be unscrewed, previously cleaned of dirt and debris.
Good oil pressure is 20-60 psid, this is the differential between crankcase and oil pump discharge.
Sight glass and crankcase heater can be installed for additional demand.
This especially holds true if the compressor is a two-stage application that has intermediate pressure working on the crankcase.
The crankcase is vented via the oil separator and the oil breather, which allows operation with minimum oil carryover.
Place a gauge manifold on the oil pump discharge and one on the compressor crankcase, the difference is net oil pressure.
The pins are lubricated by splash from the crankcase, by oil forced through drilled passages in the connecting rods, or by the use of piston oil spray nozzles.
The rings must form a tight seal to prevent lubrication oil from getting into the combustion space, which could lead to increased engine emissions, and to prevent combustion gases from entering the crankcase.
The piston head need to prevent the high temperature, high pressure gas into the crankcase, and prevent oil from entering the combustion chamber;
Description Automobile Engine Transmission case A crankcase is the housing for the crankshaft in a reciprocating internal combustion engine The enclosure forms the largest cavity in the engine and is located below the cylinder s which in a….
The excellent wear performance of Shell Rimula R6 LM together with piston and crankcase deposit control helps to deliver long and reliable engine life.
Description- Automobile crankcase HPDC die Along with Cam Carrier, another critical category of products for engines is Crank case. Xinyu Mould has also mastered the manufacturing process by deploying the same world class manufacturing cells for….
The piston head is the seat of the part above the Piston Pin, piston head of the Piston Ring, to prevent the high temperature, high pressure gas into the crankcase, and prevent oil from entering the combustion chamber;
The oil and gas separator is connected to the engine crankcase ventilation valve. Mainly because when the engine works, the cylinder of the channeling gas and oil vapor will produce pressure, then it is harm to the engine, crankcase ventilation valve take out of the gas but there are a lot of oil vapor inside, so the oil and gas separator is….
On the U-shaped, D-shaped or T-shapedthe handle is attached to the bar, located trimmers controls. The cutting mechanism is surrounded by a special casing. Dressed with everyday brushcutters mixture prepared from gasoline and oil, which is poured into the fuel tank. The device prosumer and consumer brushcutters equipped with a four-gasoline engine is slightly different. charging circuit is also different: the oil is poured into the crankcase, and gasoline- in the tank.