Examples of using Maximum voltage in English and their translations into Ukrainian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Do the exercise with the maximum voltage;
Maximum voltage and switching current: 36 V DC/ 3 A.
Final Charge with maximum voltage up to 100% battery capacity.
It provides the necessary protection and 50W output. Maximum voltage is 9.9V.
The maximum voltage is 200 V in this case.
Here the importantprinciple is to obtain a maximum voltage at its secondary**.
Allowed maximum voltage for USB charging ports 5V.
For recharging, a solar panel with a power of 2W and a maximum voltage of 6… 18V is suitable.
Allowed maximum voltage for AC electric outlet 250V.
Thus, on its edges, we get the maximum current, and in the center of the maximum voltage.
The maximum voltage supplied to the inputs of the monitor up to 30 in.
The powerful high-voltage battery has a maximum voltage of 405 V and a nominal capacity of 230 Ah.
The maximum voltage drain-source on-they must have not less than 55V.
The slot also supports adaptive energy technology Delivery, adjusting the maximum voltage of the device.
At the moment of maximum voltage should be delayed for a few seconds.
After passing through the resistance and the Zener diode, the current has a maximum voltage amplitude of 8.9 V.
However in this case the maximum voltage is better to be reduced to 15V.
The maximum voltage of the investigated capacitors must be 1000 or more volts.
It is assumed that the torus is at the maximum voltage and is connected to the upper output of the coil.
The maximum voltage value set for AGM-batteries is in the range from 14.2 to 14.4 volts.
Since both wires have a varnish insulation, the maximum voltage from the HV you need to submit less(to avoid breakdown).
Atis Exit-PE exit button mechanical, contact, overhead, NO, plastic case.Power supply DC 12 V. Maximum voltage: 3 A.
At the same time, maximum voltage, drain-source they should be at least 250V. Perfect- IRFP260.
In the case of electromagnetic waves,the amplitude can be interpreted as maximum field strength or maximum voltage.
On the secondary side we will have to obtain the maximum voltage that will depend on the duration of the pulses in the primary windings, their inductances, capacitance CP and the load resistance RL.
Exit button mechanical, contact, overhead, NO, plastic housing.Power supply DC 12 V. Maximum voltage: 10 A. Dimensions: 60х60х40 mm.
Exit button mechanical, contact, overhead, NO/NC/COM, plastic housing.Power supply DC 12 V. Maximum voltage: 3 A. Dimensions: 76х23х14 mm.
Here you need to remember that TT is a quarter-wave long line,but because one end will be a maximum voltage, the other the maximum current.
This mode is set by the generator of E2, while in the parallel-to-serialcircuit L1C1L2C2 needs to be a resonance, and the maximum voltage should occur in the coil L1.
It should be noted that as a key transistorneed to choose a MOSFET with a small on-resistance and maximum voltage closed- not less than 500V. Optimal 47N60.
