Examples of using Layer thickness in English and their translations into Arabic
{-}
-
Colloquial
-
Political
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Layer thickness- 3-4 cm.
LVT Tile Thickenss, wear layer thickness, dimensions.
Layer thickness: 0.05mm.
Coverage depends on the layer thickness and the planned activities.
Layer thickness: 5-25 microns.
The ideal would be adhesive layer thickness of 6 mm. apotol.
The layer thickness is usually the same- from 30 to 60 mm.
According to single paint, the layer thickness cannot be lower than 26μm.
Each layer thickness can be adjusted freely, no need to stop the machine.
Hot dipped Galvanizedsteel wire must ensure the zinc layer thickness.
Maximum layer thickness- 5 cm;
Take the first fragment and causenotched trowel adhesive layer thickness of 5 mm;
Covering layer thickness range small(1) 6 to 90mm.
Hot-galvanzied Treatment upon surface with average layer thickness 85μm.
The smaller the layer thickness, the less the strength of the floors;
Distance, uniform, fixed width above standard anticorrosion layer thickness of spiral duct tape, not influence.
Measuring zinc layer thickness is necessary process before shipment.
Layer thickness: No more than 5-6 mm is applied to a well-milled infrastructure.
What is precision/ single layer thickness of NOULEI 3D modeling machine?
Layer thickness on the concrete and the brick is less than 5 mm, on a grid or shingle to 10 mm.
As for double paint, the layer thickness cannot be lower than 45μm.
Reduce layer thickness, increase available void space and reduce costs of construction.
The calculator can determine the density of backfill ecowool, layer thickness, the total length of all the walls, the height and density of the insulation.
When the layer thickness of 2 to 15 mm need 3 hours for drying the floor to be able to walk on it.
In such procedures a clay layer thickness must be at least two centimeters.
With the layer thickness(d) and the conductivity(l) the heat transfer resistance Ri = d/ l is calculated for each individual layer. .
Fastened Z axis motor to make the layer thickness more precise, dual ball screw for Z axis.
Note acrylic layer thickness: ideally, it should not be less than 6 mm.
When the water is disinfected, the water layer thickness should be less than 2cm, the water flow out of time to accept 90000 UW.
Sandwich pipes can have different heat insulating layer thickness and the diameter of the pipes themselves, which also depends on the type of system and its destination.