Examples of using Layer thickness in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Days depending on layer thickness.
Layer thickness, adhesion and structure.
The soil is mulched with peat, layer thickness- 3 cm.
The layer thickness of 10 cm is recommended.
Interpretation of layer thickness.
Each layer thickness could be optimized to your needs.
interpretation of layer thickness.
Uniform layer thickness(no edge effects).
Roll out the dough into a round layer thickness of about 1 cm.
The layer thickness should be equal to about two millimeters.
it all depends on the layer thickness.
The layer thickness should be more than the distance"beacons- ceiling base.".
Some amount of index inhomogeneity can appear with increasing layer thickness.
A layer thickness of less than 15 mm is quite feasible.
broken brick, layer thickness make up to 20 cm.
A floor covering's layer thickness is primarily determined by two factors.
These measures are, however, normally not as efficient as increasing the layer thickness.
Layer thickness multiplied by the width
which serves as a protective shield, a layer thickness of 1-2 cm.
Layer thickness 0.03 mm,
Build quality depends on a number of factors such as layer thickness and slicer settings.
Layer thickness is often also referred to as resolution
The system saves you manual re-measuring of the layer thickness and thereby saves time and material.
The layer thickness is usually equal to one millimeter
The temperature Ti, ice content Iiand height(layer thickness) hiparameters are closely related.
Vary the layer thickness of color bands by the number of dips before switching colors.
other drainage(layer thickness of 20 cm), is placed on top of the soil.
The screed consists of solvent-free TEKNOFLOOR 400F epoxy varnish and a sand mixture with a layer thickness of 4-5 mm.
Application of the plaster is done"over", and the layer thickness should not exceed 2 cm After that, with the help of rules.
The absorbency of the blank chloroform phase, measured against chloroform must not exceed 0,015 per 1 cm of layer thickness at 650 nm.