Examples of using Using a drill in English and their translations into Arabic
{-}
-
Colloquial
-
Political
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Embroider crack using a drill and a special nozzle.
The adhesive is diluted according to the instructions when using a drill.
Stir better lubrication using a drill armed with homemade mixer.
When using a drill with a conventional drill tile surface is easy to split.
Cooking glue is better in a plastic container using a drill with a mixer-nozzle.
Easy to install, by using a drill and screwdriver, helped with the built-in notches and spike.
Abu Bakr al-Razi:-described in his book Al-Mansouri method of drilling teeth using a drill.
In addition, it is best to do all technological holes using a drill to avoid cracking of the material.
Using a drill, create in a ground depression(the distance between the walls of the hole should be about 40 cm in length and width), the depth of this should not be less than1m;
Then the water slowly,in portions added to dry the composition and mixed using a drill with paddle-mixer.
Then, in the wall or tile drilled hole using a drill, in which the anchor is installed and screws, not forgetting the silicone sealant.
Choose a place in the wall to install the thermostat and drill a hole using a drill and bits for concrete.
In order to maximize seal the well wall must be added to a solution of PVA glue andthen the solution was mixed using a drill with a special nozzle.
If the material before us in the form of a dry mix,dilute it with water according to the instructions and will interfere with using a drill with a special nozzle to form a uniform consistency.
And you can use a drill and make holes in the already hardened basis.
Instead grinders can use a drill with a special grinding attachment.
To do this it is best to use a drill with a special crown a nozzle with a diameter of 68 mm.
If not L-shaped hexagon wrench, you can use a drill of suitable diameter, which vtravlyaetsya in one of the three holes for the clamping key.
For processing brick or concrete, use a drill in which the tips of the soft or medium soft.
If you can not buy a crown, you can use a drill with a diamond tip.
If you are unable to utilize the license plate light to route wiring,you may need to use a drill to make a small hole to route the wires;
As a result, the solution is supposed tobe thick enough to stir it thoroughly, use a drill with a special nozzle.
Paddle to stir the glue(you can use a drill, but rather specifically for this tool);
Use a drill and auger to bore 1[FRACTION 12]-inch-diameter holes into the ground inside each corner of the 2x4 base.
You can use a drill with special nozzles that allow you to process a large number of feed components.
Since the solution is mixed thoroughlyby hand is very difficult, we will use a drill or rotary hammer.
Dust can be a special knife for jointing,but a quick way to remove tile adhesive- use a drill with an attachment in the form of a round wire brush.
If the layer of finishing materials is difficult to remove,you can try"obstuchal" treatment area with a rubber hammer or use a drill with a special motorized brush attachment.