Examples of using Using a drill in English and their translations into Croatian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Knead them into a bucket using a drill.
Using a drill or grinders with a brush attachment;
Mix glue conveniently using a drill with a special nozzle.
Using a drill with a circular nozzle in the ceiling, do the required diameter of the hole.
The wall makes a hole using a drill in which the dowels are inserted.
Marked points should be marked with a pencil,drilling holes in these places using a drill.
Better if you stir the mixture using a drill with a paddle"mixer".
When using a drill with a conventional drill tile surface is easy to split.
Strip of irregularities and rust, using a drill with a special nozzle(brush, metal).
The mixture is prepared in accordance with the instructions thoroughly mixed using a drill with a paddle.
Guided make notes, using a drill and screws fasten the way to the top bar to the bottom.
Cooking glue is better in a plastic container using a drill with a mixer-nozzle.
Preparation Set on the packaging material can be stirred using a drill with a special nozzle- after it became a homogeneous consistency, leave the mixture for 15 minutes, so that it thickens slightly, then stir again. Now.
In order to maximize seal the well wall must be added to a solution of PVA glue andthen the solution was mixed using a drill with a special nozzle.
When drilling concrete walls using a drill or punch, you need to observe basic safety rules.
In a container of clean water, a dry mixture is gradually added,the solution is mixed until the consistency of the paste, using a drill with a nozzle.
Paint removed by hand- a trowel andby scraping them from the surface of the wall or using a drill and a special nozzle in the form of a wire brush.
Shtroblenie perform with the use of special impact equipment- interchangeable blades, a peak with a thin tip bit anddrill bits, using a drill in the drill mode.
If the material before us in the form of a dry mix, dilute it with water according to the instructions andwill interfere with using a drill with a special nozzle to form a uniform consistency.
To drill on the tile does not slip, stick to place the intended aperture masking tape ormake a small depression in the tile using a drill with a sharp tip of the spear.
If you fail to do this carefully, use a drill with a thin bit.
To do this, use a drill.
If you can not buy a crown,you can use a drill with a diamond tip.
Self-made concrete mixers of vibration type use a drill and a special nozzle.
For processing brick or concrete, use a drill in which the tips of the soft or medium soft.
As a result,the solution is supposed to be thick enough to stir it thoroughly, use a drill with a special nozzle.
Who has not got it in everyday life fit and construction tool,can use a drill, having bought it necessary nozzles in the set or separately.
To qualitatively make a hole in the tile anddoes not damage it, you must use a drill whose cutting edge is much harder than the surface of the tile.
When manually kneading a tile mixture, instead of a shovel,you can use a drill with a nozzle for mixing solutions;
This may be used a drill with a special nozzle-mixer.