Examples of using When mounting in English and their translations into Arabic
{-}
-
Colloquial
-
Political
-
Ecclesiastic
-
Ecclesiastic
-
Computer
When mounting it tightly fit in effortlessly.
Spacers will be used when mounting on a flat surface.
Grease lubrication of the outer surface may be necessary when mounting.
When mounting is necessary to consider the size of the structure and padding.
Glue consumption of dry mix when mounting to a wall polystyrene- about 6 kg per 1 m2.
When mounting and installing stairs, you need to know its exact height.
The 360 degree interlocking method is used when mounting the joint hidden roof panels.
Especially when mounting the board was conducted using hidden brackets.
Angle iron creates a natural stand-off to a vertical surface when mounting it to a wall or casework.
When mounting do not forget his forge, What would wind not babbled them.
There are several points that you should pay attention to avoid mistakes when mounting tension ceiling.
When mounting the plates do for her support of the soft rubber or penofol.
And, interestingly, this has been observed in female macaques, but only when mounting another female.
This should be considered when mounting partitions made of plasterboard with their hands.
The connection surface of the divider and pipe should be smooth,the installation bolts should not be too tight when mounting the divider valve.
When mounting is required to build an additional waterproofing layer of rolled materials.
When mounting this type of ceiling, the gaps between the slats are filled with metal strips.
Another important design feature is that theSidewalls can be pressed from both sides when mounting, this offers much higher bond strengths and security.
When mounting the thermostat, place the sensor in the corrugated pipe and position it above the level screed.
They are easy to handle when mounting and dismounting and are able to accept misalignment caused either by Shaft deflection or inaccurate positioning.
When mounting glue- it is applied to the panel in long strips with an intermediate distance of 5 to 10 cm.
When mounting the beam in the wall of drywall use special anchors, which is popularly known as"butterfly".
When mounting the pvc panels the seam between the panels must be almost not noticeable visually and by touch.
When mounting on concrete or drywall, first drill ¼ inch holes and insert anchors before screwing mounts in.
When mounting your motors by means of binding agents, DOn't flow any adhessice to the Bearings nor intrusion into the motors.
When mounting the first closed pipe shtrobiruyutsya wall(at appropriate locations groove width is done in two pipe diameter).
When mounting the plinth at the wallpaper, the surface does not require special training, but in this case for sticking adhesives are applied on a polymer basis.
If when mounting the motor and assembling the unit, equipment which emits ultrasonic waves is used there is a danger that some of the internal parts of the motor might be damaged so please take care.