Examples of using Maximum deviation in English and their translations into Greek
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Official/political
-
Computer
Maximum Deviation± 50KHZ.
Amount} is the positive slippage the order received beyond the maximum deviation.
The maximum deviation of 0.5 cm.
This MetaTrader 4 execution type enables the maximum deviation("max deviation") feature.
Maximum deviation from straightness 2.5mm/m.
If the market price moves negatively beyond the maximum deviation, the order cancels automatically.
The maximum deviation of nominal sizes must not exceed.
You will get perfectly straight and highly accurate cuts with a maximum deviation of only 1 mm per metre.
The maximum deviation feature was designed to control slippage.
Even when the temperature was increased to 500°C, the maximum deviation in brake output was shown to be as low as 4.5 percent.
The maximum deviation of the section height and width shall not exceed.
Therefore, FXCM has developed a way to override the restriction that the maximum deviation feature places on positive slippage.
The maximum deviation from a straight line along its length is the quantitative measure of its straightness.
In the event that an order fills with positive slippage beyond the maximum deviation, the platform logs a message in the"Journal" tab.
Dial calibration The maximum deviation of the indicated value from the actual value should be less than± 10%.
None of the maximum values of the samples can exceed the maximum deviation limit of 1 log unit from the indicated value for E.
The Maximum deviation of the actual tunnel axis from the design tunnel axis in horizontal and vertical axes is+/- 40mm.
Accuracy"(2 6), usually measured in terms of inaccuracy,means the maximum deviation, positive or negative, of an indicated value from an accepted standard or true value.
The uncertainty for modelling is defined as the maximum deviation of the measured and calculated concentration levels for 90% of the individual monitoring points in the period concerned in relation to the limit value(or target value by ozone) without regard to the timing of the events.
It is defined as the actual characteristic curve and fitting than the maximum deviation from a straight line with the full-scale output value in the whole range.
Please note: dependent upon market conditions,a lower maximum deviation amount can increase the likelihood that an order will be rejected due to the market price moving outside of the maximum deviation.
Thus, the bubble level, even the best, according to the passport data,has a maximum deviation of 5 mm for every 10 m, but in reality the situation is somewhat worse.
Please note: dependent upon market conditions, a lower maximum deviation amount can increase the likelihood that an order will be rejected due to the market price moving outside of the maximum deviation. Net Stops and Limits.
The accuracy for modelling andobjective estimation is defined as the maximum deviation of the measured and calculated concentration levels, over the period considered by the limit value, without taking account the timing of the events.
The uncertainty for modelling andobjective estimation means the maximum deviation of the measured and calculated concentration levels, over the period for calculating the appropriate threshold, without taking into account the timing of events.
The uncertainty for objective assessment method is defined as the maximum deviation of the measured and calculated concentration, over the period considered, by the limit value(in respect of ozone- target value), without taking into account the sequence of the events.
The uncertainty in connection with objective estimation is defined as the maximum deviation of the measured and calculated concentration levels, over the period considered, in relation to the limit value(or target value by ozone) without regard to the timing of the events.
Linearity”(usually measured in terms of non‑linearity)means the maximum deviation of the actual characteristic(average of upscale and downscale readings), positive or negative, from a straight line so positioned as to equalise and minimise the maximum deviations. .