Examples of using To the sensor in English and their translations into Korean
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Programming
-
Computer
He never shows his face to the sensor.
Is a High-Tech enterprise committed to the sensor, control instrumentation and control systems engineering.
Can the RF tag be connected to the sensor?
You can also add a small strip of tape to the sensor to ensure that it does not fall out.
As discussed above, TEDS must always be inseparably linked to the sensor.
So we attach this light-sensitive switch of channelrhodopsin to the sensor we have been talking about and inject this into the brain.
Silicone oil is used to transmit the process pressure to the sensor.
In order to have the 4K output, there are more signal input to the sensor.
However, as discussed in the previous section, tilt in relation to the sensor will negatively impact the actual image quality that the system produces: the higher the number of pixels, the more profound the effects.
Positioning the object to be detected within the desired distance(1) to the sensor.
Note that PIRs won't tell you how many people are around or how close they are to the sensor, the lens is often fixed to a certain sweep and distance(although it can be hacked somewhere) and they are also sometimes set off by housepets.
Equipped with different intelligent flight modes, it will allow you to take amazing photos thanks to the sensor….
In addition, the atmosphere will further attenuate the signal propagating from the target to the sensor.
Note that PIRs won't tell you how many people are around or how close they are to the sensor, the lens is often fixed to a certain sweep and distance(although it can be hacked somewhere) and they are also sometimes set off by house pets.
Activation of the sensor also provides connection LM335"Pull Up" resistor to 3V3 which provides power to the sensor.
By positioning the object to be detected within the desired distance(1) to the sensor, pressing the button for approx.
Preventive maintenance The sensors allow display of an uncertain sensor state directly on site using the LED display if the actuator is no longer close enough to the sensor.
Transmit pulses and a gate signal from the microprocessor route through the analog signal processor to the sensor, which sends an ultrasonic beam to the liquid surface.
One of the greatest advantages of IO-Link is the possibility to transfer all necessary parameter data via the IO-Link connection cable to the sensor.
It will help ensure that the pulses that it generates are strong enough to be able to reach the target and return to the sensor.
This connection can be made via anextended length cable from the sensor that is hard-wired directly to the instrument, an extension cable connected to the sensor at its point of use, or by transmission via a wireless network.
Air and gas stream measurements are a challenge because the rate of transfer of temperature from the fluid to the sensor is slower than for liquids.