Examples of using Software raid in English and their translations into Polish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Financial
-
Official/political
-
Programming
-
Computer
BTW, software raid is working VERY nicely.
I like the redundancy that simple software raid gives.
MD/Software RAID Support in debian-installer.
Here are a few other notes on linux software raid.
But isn't software RAID a lousy way to do it.
When I'm talking about playing around with software raid under ubuntu linux, but….
Linux software raid seems fairly reliable so far- 2 years.
This option is available if two or more software RAID partitions have been configured.
Software raid- the linux kernel does very good software raid. .
Next step is to create the"merged" MBR+/dev/sdaN disk image using software RAID.
First… from the software raid howto, I have done the following….
All in all, this upgrade could have been disastrous- booting from the software raid device could have failed.
The software raid array doesn't care what KIND of devices you have added.
The Quad X supports up to four drives andcan use software RAID to achieve high data transfer rates.
Create a software RAID partition Choose this option to add a partition for software RAID. .
Create a RAID device Choose this option to construct a RAID device from two or more existing software RAID partitions.
In sum- replacing drives in a software raid array is quite simple- especially if they're the same size.
If your RAID controller is not yet supported by dmraid,you may combine drives into RAID arrays by configuring Linux software RAID.
You can do this using software RAID in linear mode(you need the linear. ko kernel driver) and a loopback device.
First, I should disclaim that this is going to be a brain dump of the resources andexperience of a quick setup of Ubuntu 6.06 on a software raid based storage system.
Our software RAID uses the Marvell SATA controller and Intel CPU to give our NAS devices fast performance levels.
I did a vmware environment for this with the ubuntu alternate install disk(dapper),gave just one drive initially, setup software raid with 1 active device.
Anyone that's setup software raid on a system with multiple storage adapters has probably run into this kind of issue, but I thought I would mention it.
Yes, there are hardware raid controllers,(there are psuedo-hardware controllers too that still require*gasp* software…) But, for this purpose,I thing software RAID should do fine.
Bottom line, software raid is impressively good and easy to get started with at least with the ubuntu installer, haven't yet tested with the mandriva installer or others.
The default raw disc detection routine from qemu often results in non kilobyte-roundable offsets(such as 31.5 KB, as in the previous section)that cannot be managed by the software RAID code.
Well, the biggest frustration I have had has not been with software raid, or any of the rest of the software setup, but that something about the firewire/usb card didn't like the built in ethernet.
I seem to recall the localization question being new in the installer, butthen it's been a while since I used the ubiquity installer used the alternative install to setup software raid based systems.
First it was because“you don't want to do software raid” and I didn't have a card to support hardware raid, then when I first was seeing people raving about how good linux software raid is, I didn't have two free drives of equal size to work with.