Examples of using Displayed value in English and their translations into Russian
{-}
-
Official
-
Colloquial
Simultaneously displayed values(configurable).
Displayed values may differ due to rounding.
The actual flow is higher than the displayed value.
Displayed value Description Running The pump runs.
Use a thin soft pipe,less than the displayed value.
People also translate
The displayed value is the conducting-state voltage drop.
Use a thin soft pipe,less than the displayed value.
The displayed value will change depending on the leg movement.
For calibrating and checking the displayed values of common pH meters.
The displayed values and the order are taken from the normal view.
Then briefly press the On/Off button 5[] to delete the displayed value.
For deviating temperatures the displayed value can be compensated manually.
If in doubt about the correct sensor,disconnect the sensor and check the displayed value.
Added option to limit the number of displayed values for each feature.
The lower the displayed value the better the signal quality and lower the bit error rate.
When measuring on welded meshes the displayed values must be corrected.
The displayed value is an average of the measured volume of softened water over the last minute.
The Ø icon is used to indicate that the displayed value is a diameter value. .
Navigates downwards through a list or decreases the numeric value of a setting Enters into a menu orsets the currently displayed value.
By pressing[ 2ndF][ ed], the displayed value will be converted to the improper fraction.
Factory calibration certificate stating the error between the workspace temperature& the displayed value at 700 C, 900 C,& 1100 C.
By pressing[ 2nd][ A b/c d/e], the displayed value will be converted to the improper fraction and vice versa.
These settings also apply to the values displayed on the display and adjustment module if in the menu item"Displayed value" PA-Out was selected.
Rotating the Display To make the displayed value easier to read, press button 13 to rotate the display. .
Input dischargevolume to the measured piece Cx through JZF series PD external calibrator,adjust the fine adjusting knob till the displayed value is equal to the dischargevolume, the discharge can be read directly and conveniently on the meter without counting.
Press the key“Up/Down” again to change the displayed value from a minimum of 15 C to a maximum of 40 C 59÷104 F.
Traverse the X axis until the display value is zero.
LED digital display value is for reference only.
Traverse the X andY axes until the display value is zero.
Non-SIL parameter 2: Display value 1, unit of application.