Examples of using Soap solution in English and their translations into Russian
{-}
-
Official
-
Colloquial
Bubble gun and soap solution peddler.
Soak the sensor for 2 to 3 minutes in the soap solution.
Spray bottle of soap solution for leakage test.
You may also use isopropyl alcohol or a soap solution.
The soap solution can be applied with a spray bottle, brush or rag.
Additional spray gun for a soap solution with brush.
Make a soap solution of one part liquid detergent and one part.
All leak tests should be done with a soap solution.
Non-abrasive soap solution: 1 per cent by weight of potassium oleate in deionised water;
It is also advisable to periodically replace the toothpaste on a soap solution.
The spray gun of soap solution with a stainless steel tank with a capacity of 5 liters.
Turn the regulator(8) back to On andcheck once again using the soap solution.
Spraying plants with potassium soap solution covers them with a protective film.
In case of need,clean with damp cloth moistened in a baby soap solution.
Disposable liquid gas canister, soap solution and a cloth or brush to apply the solution. .
The most serious contamination can be overcome with the support of a usual soap solution.
After using the MVH, rinse the components in a soap solution to remove residual products and wipe.
Clean up the polluted Light fixture components by soft rags,watered in the light soap solution.
Soap solution and ammonia(standard"Zelenka" and iodine can be used only in the last place).
Remove heavier stain using warm water and liquid cleaning agent or a soap solution.
A mild soap solution consisting of 2 tablespoons of natural soap to 1 litre of lukewarm water.
When the front panel becomes dirty, use a soft cloth,slightly dampened in a weak soap solution.
If a stain appeared on the mattress,use a soap solution with a cold water or an upholstery shampoo.
Program is heldby professor Puzyrikus and reveal the soap bubbles and soap solution secrets.
Rinse the sensor with water and return to the soap solution for 2 to 3 minutes to neutralize any remaining acid.
Chromed and anodised surfaces should be cleaned regularly using a liquid detergent with a neutral pH or else soap solution.
While wet felting people should use a soap solution, which helps to entangle wool threads with each other quickly.
Soap solutions in water can remove dirt, which is a mixture of soot, silica, mineral salts, and dusty matter, glued together by the proteins and fats contained in sweat.
Soiling that is water-soluble can be cleaned off with a mild soap solution or gentle abrasive using a sponge or soft brush.
Hydrogen leakage is evaluated at accessible sections of the fuel lines from the high-pressure section to the fuel cell stack(or the engine), using a gas detector or leak detecting liquid,such as soap solution.