Examples of using Circulation pump in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Why do you need a circulation pump.
Siemens Circulation pump+ heating element(00651956).
P2 is DHW primary circuit circulation pump.
Circulation pump Wilo RS 15/6 130mm Fluorescent.
Check that the heat source and the circulation pump are in operation.
The circulation pump provides a continuous flow of water.
To enhance coolant flow in the system, set the circulation pump.
Can be used as an engine heater(if circulation pump is connected on the engine side).
Coolant required operating pressure is achieved by means of a circulation pump.
A circulation pump is needed to move the water(for hot/cold transfer) through the system.
By the control unit can be connected to a specialdevice- the circulation pump.
Can be used as an engine heater(if circulation pump is connected on the engine side).
Electrical heating cartridge in stainless steel with 230 V circulation pump.
The basket on the circulation pump is used to collect larger contaminants from the filtered water.
The calculations are carried out shows that the circulation pump is correctly sized.
Install circulation pump and strainer on the return pipe to the circulating pump and the entrance to the boiler.
However this advantage is tradeoff by higher energy consumption of the circulation pump.
As additional equipment for this system using a circulation pump, thermostat, safety valves and air vent.
Pressure increases, reaching a required value without auxiliary machinery such as a circulation pump.
This water is supplied to the heater of the heating system with the circulation pump, the operation of which is governed by the special valve.
It is found that rules the proposals is estimated to halve the energy consumption of the circulation pump.
Note: It is not advisable to use a circulation pump in winter, as this will transport the cold water from the surface into the depth.
Has an acceptably low pressure drop to minimize circulation pump power consumption.
The circulation pump is inserted into a gravity heating circuit, if the system can not
then starts the circulation pump, which is located in the storage tank.
An important practical conclusion is that, the energy consumption of the circulation pump in the heat pump is roughly proportional to the third power of the flow rate.
and switches off the circulation pump, which is carried out through the"movement" of coolant.
This equipment is equipped with not only a torch andheat exchanger, and a circulation pump that pumps a constant pressure in the system.
The microprocessor then controls the corresponding two circulating pumps or a circulation pump and a bypass valve via relay.
When using the wall with a copper boilerheat exchanger in combination with circulation pump, ie pump, steel pipes will only interfere.