Examples of using Remote access server in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Double-click Connections to Microsoft Routing and Remote Access server.
If your remote access server supports this feature, you may notice improved audio quality.
If you enable this option, you may not be able to connect to other remote access servers.
For large organizations, the remote access server is attached to a modem bank containing up to hundreds of modems.
at least one analog modem at the remote access server.
Typically used if the remote access client and remote access server cannot negotiate a more secure form of validation.
a virtual circuit to a port on a remote access server.
Specifies whether this computer is enabled as a remote access server, which supports either dial-up or VPN connections.
The remote access server must be using a V.90 digital switch and must be connected
Specifies whether this computer is enabled as a remote access server for IPv6 traffic,
infrastructure to connect to a remote access server.
If you want the remote access server to support multiple, dial-up networking TCP/IP-based connections, complete the following steps.
The security settings you assign to a dial-up networking entry must match the settings on the remote access server to which this entry corresponds.
By configuring RRAS to act as a remote access server, you can connect remote or mobile workers to your organization's networks.
Any additional networks available through routers connected to the remote network are accessible only if the default gateway for the client is changed to the remote access server.
The remote access client receives verification that the remote access server that it is dialing in to has access to the user's password.
The remote access server answers the call,
When a BAP-enabled remote access client requests another connection, the remote access server sends back a message that contains the phone number to dial for the new connection.
Unauthenticated access with remote access clients can occur when the authentication protocols configured by the remote access client do not match those configured on the remote access server.
On the Managing Multiple Remote Access Servers page, select whether you want to use a centralized RADIUS server to authenticate your network clients.
In dial-up networking, a remote access client makes a dial-up telephone connection to a physical port on a remote access server by using the service of a telecommunications provider, such as analog telephone or ISDN.
the selected authentication protocol is not permitted on the remote access server.
In dial-up networking, a remote access client makes a dial-up telephone connection to a physical port on a remote access server by using the service of a telecommunications provider,
traffic to the logical interface of a remote client is forwarded to the remote access server.
logical connection between the remote access server and the remote access client is facilitated by dial-up equipment installed at the remote access client, the remote access server, and the WAN infrastructure.
If you have more than one remote access server, instead of administering the network policies of all the remote access servers separately,
creates a temporary logical interface, and requests that the remote access server assign an IP address to this logical interface, the remote access server assigns the IPv4 and IPv6 addresses specified in the remote client's user account.