Voorbeelden van het gebruik van Switch must in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Medicine
-
Official
-
Ecclesiastic
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
This switch must be killed first.
Invalid command line switch! Switch must start with'-'!
The switch must be set at the«0»(= off) position.
In order to achieve correct gamma, switch must be toggled
The switch must be on before charging.
Over Mars. had to crank the chicken switch Must be a scout… going toward Earth.
The switch must be in a certain position before the lamp lights up.
For products with lower density, the switch must be set to> 0.5 g/cm³(0.018 lbs/in³).
The switch must be easily accessible
If an external aerial is connected to the iNet Box, the switch must be set to"ext.
The LL/INT switch must be set to INT.
Sometimes it happens that the switches cease to transfer the chain to other stars or the switch must be set to change the speed.
The cam of the switch must first pass through the opening.
If there are several frequency channels, the simultaneous switch must be made manually. Dispatcher.
The on/off switch must first be released
Some machines will have a little snowflake symbol that the operating switch must be turned to in order to freeze the mixture.
The switch must be reset after operation otherwise it can not be used again.
operation of the test object, the switch must not be actually carried out.
That the operating switch must be turned to in order to freeze the mixture.
So then the first switch must have happened between the taxi and the lobby.
This is due to the fact that this type of switch must be held constant,
This situation is due to the fact that the switch must always hold, and the presence of the blocking mechanism will achieve further insurance against injury.
Damaged switches must be replaced by a customer service facility.
Any defective switches must be replaced at an authorised servicing centre.
Secondary Switches must be set to a unique BANK address(from 00 through 15).
For all other states the switches must be edited in the. osm-file with a text editor.
Also, the switches must be in all areas near the doorway,
Due to different absorption profiles, switching must not be done at a 1:1 ratio.
Titration in patients switching from other fentanyl containing products Due to different absorption profiles, switching must not be done at a 1:1 ratio.
sockets and switches must be in easily accessible places.