Primjeri korištenja Second end na Engleski i njihovi prijevodi na Hrvatskom
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
According to the second- end.
Wait a second, end of May?
It is My Baby,Concentrator and Second Ending.
The second end of the hose attached to the pump.
Then sew up the second end thereof.
Ljudi također prevode
The second end of the cable is fixed on the car.
Leave the loop hang neatly with the second end of the scarf.
The second end of the string is tied to a tensioned wire.
Down to the wire, it's Second Ending the winner by a length.
The second end should be lowered into a jar with brake fluid.
Leave the loop hang neatly with the second end of the scarf.
The second end is fed to the top of the sewer pipe.
Align the board exactly horizontally using a spirit level and attach it the second end to another tree.
According to the second- end. documents for inspection!
Second Ending, moving up, is third, and Comfort King.
After closing the valve, the second end of the hose(tube) is connected to a tank.
The second end of the line is passed through the beads on the other side.
In addition, the single-core cable will have to be laid on the area when creating the circuit,taking into account the return of the second end to the thermostat.
At the second end of the mine, a bowl(chilim) is put on.
It is necessary to cut the same stripes of any length(not more than 1 cm wide) and form a link after the link, passing one end of the chain to the previous link andgluing together with the second end.
To the second end.- Bets are laying that the Cutter rink doesn't make it.
Screed-harness worn on the rafter-tightening knot, and the second end is delayed or a beam attic floor, or on or driven into the stone masonry at a distance of about 30 cm from the top edge of the wall crutch.
The second end of the twine is thrown through the trellis and also tied to a loose loop.
The conductors at the second end are short-circuited and insulated, thus ensuring the shortest length of the supply cables.
At the second end, the gear wheel from the starter should be located, in this case it was used from GAZ-51.
From the second end cut the heater to the depth of the ledge bar, thus creating a self-made lock.
To connect the second end of the hinge and the hole of the hole, there is a need for a second end of the universal joint shaft.
End of second quarter.