Examples of using Reference plane in English and their translations into Croatian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
The zone is defined in relation to the reference plane and the Seat Index Point.
Reference plane The clearance zone is illustrated in Figures 3.8 to 3.10 and Table 3.3.
Controlling the trace width spacing to the reference plane to create consistent traceimpedance.
Normally the reference plane coincides with the longitudinal median plane of the tractor.
This wall must have a width of at least 300 mm on either side of the seat reference plane see Figure 3.
A vertical plane D1 E1 E2 D2 perpendicular to the reference plane 40 mm forward of the external edge of the steering wheel;
For example, laser optical displacement measurement is to turn the laser flight time into the distance between the measured point and the reference plane.
The rear wing will be 150 mm lower 150 mm(800 mm above the reference plane instead of the previous 950 mm).
A vertical plane perpendicular to the reference plane, passing at least 40 mm forward of the steering wheel and at least 760- ah forward of the seat index point;
Various opinions have been expressed in literature on the mutual relations of reference planes used in prosthetic care of patients.
For the purposes of this Annex‘reference plane' means the plane parallel to the median longitudinal plane of the tractor passing through the Seat Reference Point S.
A surface, curved if necessary,whose generating line is perpendicular to the reference plane and rests on the back of the seat backrest.
This reference plane shall be assumed to move horizontally with the seat and steering wheel during loading but to remain perpendicular to the tractor or the floor of the roll-over protective structure.
Two portions of I1 Q1 P1 F1 andI2 Q2 P2 F2 of a vertical plane, perpendicular to the reference plane and passing(210-ah) mm in front of the SIP;
The reference line is the line contained in the reference plane that passes through a point located 140+ ah rearward and 90- av below the seat index point and the first point on the steering wheel rim that it intersects when brought to the horizontal.
Two portions of I1 Q1 P1 F1 andI2 Q2 P2 F2 of a vertical plane, perpendicular to the reference plane and passing(210-ah) mm in front of the SIP;
The reference line is the line contained in the reference plane that passes through a point located 140+ ah rearward and 90- av below the seat index point and the first point on the steering wheel rim that it intersects when brought to the horizontal.
In front of a reference plane which passes at right angles to the longitudinal axis of the vehicle and through the centre of the load-free pedal(clutch and/or service brake), very hot exhaust components must be protected if located within 300 mm in the upper zone(700 mm above ground level) and within 150 mm in the lower zone see Figure 1.
An inclined plane perpendicular to the reference plane, parallel with and 400 mm above the reference line, extending backwards to the point where it intersects the vertical plane which is perpendicular to the reference plane and which passes through a point(140+ ah) mm rearward of the seat index point;
Dr. Eppes, I have just received word of Internet chatter referencing a ghost plane sighting near Goathart Air Base.
This is a collection of planes without references or serial numbers, therefore fits all countries.