Examples of using Allowable in English and their translations into Finnish
{-}
-
Official
-
Colloquial
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
The maximum allowable is 2-4 mg/ kg.
Allowable deviation of outer diameter of titanium pipe mm.
The minimum allowable volume is 1.5 ml.
You have entered a month number that falls outside the allowable range.
The maximum allowable height of 2 mm to 1 meter.
People also translate
Dimensional tolerance. Dimension tolerance is the allowable change in size.
Total allowable catches(TACs) and quotas for 2013.
Yes, you can, but in allowable amounts 2 tbsp.
Allowable fluctuations of the menstrual cycle are within five days.
Carrier frequency allowable deviation± 200Hz.
Length allowable deviation is+ 20mm; double length should also be.
At a more mature age, the allowable rate is 130 to 90.
The total allowable catches for 2003 are set out in Table 3.
For example, in 2006, the total allowable catch was 36 000 tonnes.
Bree… well, you're not my sponsor anymore, so I assume this is allowable.
The maximum allowable simultaneous wearingpendants of three pieces.
Stainless steel tube size and allowable deviation.
Fisheries: Total allowable catches(TACs) and quotas for 2010.
Especially if you neglect the rules of admission and the allowable dose.
If the load exceeds the allowable value, it is better to sheathe timber.
NOTE: Excess baggage charges will apply to any item over the allowable weight.
Further reductions in the total allowable catches will occur in 2012 and 2013.
Standard and optimum thickness of parquet substrate- 2 mm,allowing to stay within the allowable difference.
Ming titanium chemical composition allowable deviation with GB/T3620.2 provisions.
Solution: You can accelerate the processing of messages by increasing the maximum number of allowable threads.
For any type of pump allowable level of water hardness- no more than 14 dH German unit.
Further, as you gain experience in training, the allowable mode is 4 km per hour.
Allowable gear In salmon and trout fishing the use of only the following gear is allowed.
The tolerance setting in this mode establishes the allowable wear on a given cutting edge.
The allowable costs cover only actual costs incurred for the work carried out under the contract.