Examples of using Set value in English and their translations into Korean
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Programming
-
Computer
Force control Speed Error Within±1.0% of set value.
When set value more than or equal to 10%FS, it is within.
The free run speed will be higher than the set value.
E: deviation, difference between set value SV and present value PV.
Imported LCD display screen, capable of displaying the measured value as well as the set value and time.
For safety protection only, the set value should not exceed the allowable pressure of the testing valve.
Activate this option in the Advanced mode, set value and press Run!
B, 2c simulated load, the set value should be lower than the allowable pressure of the valve under test.
If no obvious moving in scope, the bitrate will be reduced to 50% of the set value automatically.
When the current value reaches the set value, ON time and OFF time are both 0.5 seconds, the same.
Actual output frame rate is limited by the bandwidth of PCI-Express interface transfer, and it may be lower than set value.
The parameters shown above are all for reference and specific set value shall be subject to the delivery label.
Step 4: The pressure in the pipe system is released,the pressure value in pipe and equipment is restored to the set value range.
When the speed is lower than the set value, the converter will be reconnected to the motor and runs as per the set value. .
Imported LCD display screen, capable of displaying the measured value as well as the set value and time, upto 269 groups of programs;
Set value: The value given by the customer corresponds to the flow of the medium, where the fl oat top edge is aligned with a line on the sight glass.
Imported LCD displayscreen is used for the control unit, capable of displaying the measured value as well as the set value and time.
When the system vacuum pressure is greater than the set value, the controller will automatically cut off the circuit, a signal to ensure the stable operation of the system.
In winter, the ambient temperature of the device is low and the amount of heat taken increases, so offsets lower than the set value are likely to occur.
The system will provide your currently set value for the Max Open Lots setting, but you may also change it or set it to'No Limit'.
The apparatus is confi gured in such a way that when the flow is less than approximately -1% of the set value, only the float head is visible through the slot.
For example, if the current value is lower than the set value and the ON time is 0.7 seconds, the OFF time will be 0.3 seconds and the ON time will be longer.
When the detected temperature is 650℃, the motor opening is 75%, and when the detected temperature has just reached the set value, there is no deviation and the motor opening is 50%.
PID Control: The control precision is high, and the obtained signal can be compared with the set value rapidly, and instructions can be issued quickly, so as to ensure the accuracy and precision of the control and the rapid reaction can ensure the stability of hydrogen content.
NOTE: The value will be updated synchronously with 1 to 2 second delay, the delay is a normal phenomenon because the device need to receive the set value and then returned to the monitoring platform.
High intelligence: according to the test condition and requirements,the equipment can automaticly control to reach the set value with max ability and to keep the set value with the minimum ability so as to achieve the optimal control of the whole.
But Koowheel electric hoverboard K8 is special, because the max speed is 10km/h, when the motor's speed reaches the setting warning speed of 10km/ h,the warning buzzer alarms; when it below the speed limit(set value: 10km/ h), the warning buzzer does not alarm.
It is not frequency conversion air conditioner but superior to it because conversion type begins to save energy when the indoor temperature reaches the set value, while the hybrid solar air-conditioner runs in the optimal state immediately after starting and it achieves the sanme effects of traditional air conditioner with less power consumption.
Taking the electric heatercontrol as an example, in the case of ON-OFF control, the electric heater switches between the ON point and the OFF point(set value), so the amount of overshoot due to detection delay etc. will increase.
It is not frequency conversion air conditioner but superior to it because conversion type begins to save energy when the indoor temperature reaches the set value, while the hybrid solar air-conditioner runs in the optimal state immediately after starting and it achieves the sanme effects of traditional air conditioner with less power consumption.