Examples of using Set value in English and their translations into Romanian
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
-
Programming
Set Value.
The display will show the set value.
Amplitude of the set value signal in mm.
Triggering accuracy+/- 3% of the set value.
Set value 249 12 rubles consists of objects(fork, knife, spoon).
The free run speed will be higher than the set value.
The oscillation around the set value takes place in a milder manner. Overregulation is smaller.
Activate this option in the Advanced mode, set value and press Run!
B, 2c simulated load, the set value should be lower than the allowable pressure of the valve under test.
The users are notified via email in case an indicator exceeds a set value.
When middle pressure below the set value, the system will automatically start to adjust.
The disadvantage of this type of adjustment is the temperature oscillation around the set value.
When the differential current exceeds the set value, the device causes the contacts to open.
New INI entry: STARTSTAT,to override the new player char stats"rolling" with a set value.
When the leak concentration reaches the set value, the instrument will emit a continuous alarm sound.
Msession_set_data- Set data session unstructured data msession_set- Set value in session.
The drop of temperature below the set value activates the blow-in, initially at a lower gear.
Added a feature- right click on dancer to"Add Unknown Tip"- open Dancer Notes to"Set Value" later.
For safety protection only, the set value should not exceed the allowable pressure of the testing valve.
Ø termostatically controlled heating between 20 and 80 °C,with display for set value and real value from premises.
Pay attention to the set value only 1999 Russian rubles, which includes the subject 4 three raznoemkostnye pans и pan.
Actual output frame rate is limited by the bandwidthof PCI-Express interface transfer, and it may be lower than set value.
The set value is the difference in the gain for the highest frequency(higher gain) and for the lowest frequency(lower gain).
Here youneed to do is to determine the proper pressuresetting andensure that equipment is strictlycomplying with the set value.
When the speed is lower than the set value, the converter will be reconnected to the motor and runs as per the set value. .
If the boiler is reacting to temperature changes too slowly,the deviation(up or down) as compared to the set value may be too high.
The pressure set value must be higher than the test range, but it does not exceed the allowable pressure of the valve under test.
Frying Temperature and Time Setting→ Start Heating Until the Oil Temperature Reaches the Set Value and Start Feeding→ Frying→ Continuous Production.
Triggering accuracy+/- 3% of the set value Controlled screw tightening in the case of commercial vehicles in the common range of 250-850 Nm.
The operation is controlled by electric controller, and the mixing time can be set according needs,when it reaches the set value, it will stop automatically.