Examples of using Set value in English and their translations into Thai
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
A、Time set value modification.
Force rate accuracy±1.0% of set value.
B、Time set value modification(when it is time&temperature control).
Force rate accuracy±0.5% of set value.
The set value should be lower than the allowable pressure of the valve under test.
The machine would automatically shut down when operation reaches the set value.
The fast motion protection set value should be higher than the switching inrush current.
When the pressure of the mixing chamber is too big, the current exceeds the set value, the.
When the steam pressure is lower than the set value, the burner automatically starts to work.
Undervoltage protection: The voltage of the protected line is lower than the set value.
It means the difference between the controller set value and measured value of the controller.
Overvoltage protection: The voltage of the protected circuit is higher than the set value.
When it below the speed limit(set value: 10km/ h), the warning buzzer does not alarm.
Also it could automatically alarm by setting the battery discharge to standby time is less than a set value.
Memory function: automatically stores the cut length of the set value before the switch is turned off.
Big, the current exceeds the set value, the connector will automatically adjust the gland's up and down via the magnetic valve to remit the pressure.
Under normal conditions, when the boiler steam pressure reaches the set value, the burner automatically stops burning.
When the measured temperature value< set value-return difference),the relay total and low pass, total and high cut, while OUT indicator is light, the heater work;
After completing setting itself, the controller will enter into normal measuring state,the upper row PV window display measuring value, the lower row SV window display set value.
When the temperature reaches the set value, the machine will automatically enter the constant temperature state.
The nitrogen-hydrogen mixing device refers to the mixing of nitrogen and hydrogen in proportion and taking a part of sample gas to be tested by hydrogen analyzer, On the one hand, it shows hydrogen content, On the other hand, the electric signal is sent to the controller and compare with the set value of hydrogen content, and then decide the how much should be added.
When the pressure exvceeds the set value, the safety valve will open to avoid overload of the system.
Set value of temperature:Under the normal display state, directly press the data increasing key(▲)or data decreasing key(▼)to display the temperature set value, this time press(▲) or(▼) key to change the temperature set value, long pressing enables the data fast plus or minus. Without any operating conditions, the set value flashes 8 times and returnto normal display status.
For safety protection only, the set value should not exceed the allowable pressure of the testing valve.
The main motor ampere meter is installed in the electrical control panel, under normal running, when the pressure of the mixing chamber is too big, the current exceeds the set value, the connector will automatically adjust the gland's up and down via the magnetic valve to remit the pressure of the mixing chamber.
When the machine running reach the set value, can automatically stop work and the counter stop recording the times.
The Internal Rubber Mixer ampere meter is installed in the electrical control panel, under normal running, when the pressure of the mixing chamber is too big, the current exceeds the set value, the connector will automatically adjust the gland's up and down via the magnetic valve to remit the pressure of the mixing chamber.
PID Control: The control precision is high, and the obtained signal can be compared with the set value rapidly, and instructions can be issued quickly, so as to ensure the accuracy and precision of the control and the rapid reaction can ensure the stability of hydrogen content.
For the cartridge valve pressure and flow value can specify the set value, if not specified in the selection, the manufacturer will set a default value. .
Normal running, when the pressure of the mixing chamber is too big, the current exceeds the set value, the connector will automatically adjust the gland's up and down via the magnetic valve to remit the pressure of the mixing chamber.