Examples of using Balanced input in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Connecting the receiver to a balanced input.
Euroblock balanced input in line 2 right R channel 9.
TRS connector(6.35 mm) for balanced input.
Euroblock balanced input in line 2 left I channel 8.
XLR+ Jacks 6.3 combo connector for balanced input.
Figure 2: Connecting to a balanced input with phantom power.
Use balanced input connections to avoid hum and interference.
Use loudspeakers fitted with a transformer balanced input stage.
They feature balanced input connections via XLR3 and 1/4''Jacks.
This method does not provide the noise immunity of a balanced input see above.
Balanced input signal. DIP switch for DMX address selection.
Four/ six independent channels of amplification, with line-level balanced input.
Balanced input connector MIC(PDA-8A: 6.3mm Jack or PDA-10A XLR-6.3mm Jack) 2.
This XLR female 3-pin connector provides a balanced input for channel 2.
Balanced Input- The balanced input switch serves two purposes.
Combo jack with 1/4" TRS& female XLR mic- or line-level balanced input.
The balanced input allows connection of a unit with line output level e. g. mixer.
To connect the microphone to a balanced input(XLR connector), use a commercial XLR cable.
Balanced Input Combo input for XLR or TRS connector balanced and unbalanced.
Connect the unused side(Pin 3) of the balanced input to ground(Pin 1), as shown in Figure 23.
Balanced input via XLR jacks, with unbalanced connection connect pins 1 and 3 at the plugfig.
Alternatively, connect the left/right balanced outputs to a balanced input on your amplifier.
Mic/Line/Guitar Input- Connect a microphone, guitar, or line level device to this balanced input.
The balanced Input terminals of the next stage must be reversed(+) for(-) to correct for the inversion.
The input sensitivity of the balanced input can be switched from line level to microphone level and additionally be adapted with the gain control.
Balanced input via 6.3 mm(1/4") jacks, with unbalanced connection connect the body(GND) and the ring(-) at the stereo plug(fig. 3) or use a 1/4" mono plug 11.
The amplifiers incorporate balanced input for a high rejection of noise generated by long signal cables, proximity to electric wires or sources causing them.
A balanced input to the preamp/EQ electronics consists of one combo female XLR and 1/4” TRS phone jack.