Examples of using The initial value in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Providing the initial value.
The initial value of Default ASP language is VBScript.
It should not be lower than the factory value or 70% of the initial value;
The initial value is based on the length of your movie.
IEEE1188-2005 standard It is also the initial value of the internal resistance of the battery.
Even after 60000 hours of operation the brightness level of the display will be at least 50% of the initial value.
Default- The initial value of a control before it is changed by the user.
If you hit the jackpot, the amount will reset to the initial value and will begin to rise again.
Inside, the initial value of the loop variables,
when the initial value argument is not passed.
If the initial value argument is passed then current value starts from the 1st element in the array arr0.
In both cases this is not a reduction of the initial value, but rather a reduction of the rate of its growth.
Ini is the initial value we set- i to at the beginning of the animation that the“touchend”/“mouseup” event triggers.
Foldl1 means fold left, and use the first value in the-- list as the initial value for the accumulator.
The initial value of these rights for the purposes of paragraph 1 shall be calculated at the point when an outgoing worker's current employment relationship terminates.
When the internal resistance test value is higher than the initial value of 40%, it can be concluded that the battery has changed.
power consumption simply offset the initial value overhead.
Observe whether the initial value is accurate after starting up in the condition of fresh air(the initial display of CO detector is 0 PPM;
Another limitation is that the initial value of the N-R iteration should be considered strictly in the model,
until the light output reaches 10% of the initial value.
it results that the initial value for the direction must be -1 now
These represent the initial value we set- i to at the beginning of the animation
four report a decrease of at least 15% of the initial value, three report stabilisation
Upon observation of a significant decrease of the platelet count(30 to 50% of the initial value), enoxaparin sodium treatment must be immediately discontinued and the patient switched to another therapy.
Darken& mdash; changes the intensity to a percentage of the initial value. A slider setting halfway between middle
increased by at least 15% of the initial value in five countries(Ireland, Italy,
two- then each have to add to the initial value by 30-40 cm Naturally,