Voorbeelden van het gebruik van Correction factor in het Engels en hun vertalingen in het Nederlands
{-}
-
Official
-
Colloquial
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Correction factor.
N night correction factor.
Correction factor(FATC): to connect more ext.
Adjustable aggregate correction factor.
A correction factor shall be applied if necessary.
Mensen vertalen ook
Ultrasonic sensors Inductive Kplus sensors with correction factor 1.
Ref. 1- Fixed correction factor for ethnic group.
Inductive Kplus sensors for factory automation with correction factor 1.
A correction factor shall be applied where necessary.
The auxiliary electricity use correction factor F(4) is calculated as.
The correction factor is measured according to DIN/ IEC standards.
Inductive Kplus stainless steel housing sensors for factory automation with correction factor 1.
Automatic correction factor and carb ratio selection.
Inductive Kplus stainless steel housing sensors for factory automation with correction factor 1.
This correction factor may vary from manufacturer to manufacturer.
One sensing range for stainless steel housing metal Inductive Kplus sensors with correction factor 1.
KW Correction factor for calculating sound output in the octave band.
The adjusted pixel can be determined by multiplying each color channel with the correction factor.
This correction factor takes into account the permanent pilot flame power requirement.
Testing on cylindrical surfaces can be performed, but correction factors need to be applied.
Figure 15: correction factor for determining the input voltage of the diode detector.
the calculation for other conditions requires a correction factor.
A correction factor of 1 means that neither party is more to blame for the termination.
The Commission proposal already authorises a pollution cost multiplication factor known as the mountain correction factor.
Figure 16: once again the correction factor, here a part of the graph from figure 15 is enlarged.
you can also multiply the measured voltage at the DC output by a correction factor.
The values of the correction factor from figure 15 en 16 are only valid for the diode detector I have build.
This correction factor takes into account the auxiliary electricity consumption during on-mode and standby-mode operation.