Приклади вживання The power supply Англійська мовою та їх переклад на Українською
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
It indicates a problem with the power supply.
The power supply has been partially restored.
Exxon Mobil can change the power supply system in Europe.
With the power supply should not be any inaccuracies.
Illumination wires are connected to the power supply and ground;
Люди також перекладають
The power supply will be fully restored within 72 hours.
It can also damage the power supply in some cases.
It may indicate problems with the too low voltage of the power supply.
Dismantling and disconnecting the power supply without the inclusion of;
Therefore, it is necessary to introduce them regularly with the power supply.
Put a tick opposite the power supply and add the minimum population.
Break through the technology limit, upgrade the power supply system.
Then connect the power supply and equip the place leaving water after cleaning.
In turn, our German friends laid the power supply at 5.55.
During this time, the power supply systems of turbines and reactor cooling were severely affected.
From May 23,Voda Donbasa will be partially disconnected from the power supply.
After that, try to track all these cases and control the power supply.
As per usual, The abbreviation for the power supply system with direct injection.
He said that repair work is underway to restore the power supply.
Close the valve, and then connect the power supply to let the motor operate.
He said that repair work is underway to restore the power supply.
Supporters and opponents of the power supply system has a lot of years of debate and can not reach a compromise.
I would like tonot have the laptop continuously connected to the power supply.
Two components make up the system, the power supply and the LED module.
Providing power to enterprises and factories when disconnecting the power supply.
For Canada, the U.S.A. and Japan, set the power supply frequency to 60 Hz.
Short circuits between the power supply output and ground can create currents within the system that are limited only by the maximum current capability and internal impedance of the power supply.
Protect motors and other equipment from unstable voltages in the power supply system.
At the moment,the emergency crews have already restored the power supply in this area.