Примери за използване на Working fluid на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Preparation of the working fluid.
Working fluid- Air, water, oil and other gases and liquids;
Oil shock absorbers use oil as the working fluid.
The working fluid should be used on the day of preparation.
Minimum or zero risk of contamination of the working fluid.
Engine oil is used as a working fluid for a hydraulic jack.
Only hydraulic oil should be used as a working fluid.
The flow rate of the working fluid is 100 ml per 10 kg of planting material.
Low weight due to the minimum quantity of working fluid in the panels;
Hydraulic or working fluid is an oil that is squeezed out in a cylinder.
Its design consists of a housing,a piston and a working fluid, that is, oil.
The working fluid can be water or, more generally, hydraulic fluid. .
This device is based on periodic cooling and heating of the working fluid.
Working fluid is consumed at a rate of 2 liters per 100 square meters.
All of these methods increase the mass of working fluid in the thermodynamic cycle.
To make the working fluid, the spray tank is poured into a quarter with water.
It is necessary to constantly monitor the amount of working fluid, its quality.
The working fluid is: fuel, oil, cooling liquids, technical gases, air and others.
It serves not only as a reservoir for the working fluid, but also as a real cylinder for the piston.
The working fluid in a Rankine cycle follows a closed loop and is reused constantly.
In a double acting engine, the pressure of the working fluid acts on both sides of the piston.
The idealised Stirling cycle consists of four thermodynamic processes acting on the working fluid.
Otherwise, there is a spreading of the working fluid, which leaves the volume that is reserved for it.
The working fluid, in its gaseous state, is pressurized and circulated through the system by a compressor.
The main bearing elements of this device are the body, the working fluid and the piston, which can be extended.
In this turbine the working fluid changes pressure as it moves through the turbine, giving up its energy.
The idealised Stirling cycle consists of four thermodynamic processes acting on the working fluid: Isothermal expansion.
Instead of old oil, a new working fluid is poured, but only after the installation of a new repair kit.
It is determined by nature, more precisely,by the electronic structure of the working fluid(the medium where this radiation is generated).
This is not the case in the case of an internal combustion engine where the heat is released in the process of combustion inside the working fluid.