在 英语 中使用 The test method 的示例及其翻译为 中文
{-}
-
Political
-
Ecclesiastic
-
Programming
(3) The test method used;
It is dependent on the test method used.
The test method is ASTM D1238.
Second, we need to understand the test method for seal life.
The test method is determined by the manufacturer.
人们也翻译
It is non-destructive testing, and the test method is simple.
The test method currently approved by the Commission is:.
Note 2: The test method is not applicable to liquefied gas mixtures.
It belongs to non-destructive test, and the test method is relatively simple.
The test method for lead release is no longer restricted to EN 71-3.
This will depend on the test method used to diagnose the infection.
The test method depends on the experience of the inspector.
He shall not be responsible for the choice of the test method or technique to be used nor for the assessment of test results.
The test method depends on the experience of the inspector.
Therefore, we should be realistic and take the test method as the starting point, choose a constant test box or an alternating test chamber.
The test method mainly depends on how many steps the computer can take in one second.
To accurately detect the inductance and quality factor Q of an inductance coil,special instruments are generally required, and the test method is more complicated.
Typically, the test method involves a test statistic and a sampling distribution.
For any particular application, the test method specified needs to be completed by supplementary information.
The test method should be developed from the original qualitative, semi-quantitative to quantitative and separately quantitative.
The test method generally adopts"GB/T 12027-2004 Plastic, film and sheet heating dimensional change rate experimental method".
(iv) Choosing the test method and the preparation of the samples consistent with these evaluation criteria.
The test method is similar to the low frequency, but the frequency spectrum analyzer is used to represent the noise.
The test method is based on the fact that all electrically insulating coating materials have a much higher disruptive strength than air.
The test method is applicable to spin-on filters with a maximum flow rate of less than 100 L/min and removable filters with a disposable filter cartridge.
The test method documented in this standard describes a consistent method to assess the immunity of an equipment or system against a defined phenomenon.
The test method does not cover gas decomposition under process conditions in chemical plants and possible dangerous reactions between different gases in gas mixtures.